Scag Power Equipment MAG manual Grease Fitting Lubrication Chart

GREASE FITTING LUBRICATION CHART

	LUBRICATION					NO. OF
	LOCATION	INTERVAL		LUBRICANT	PLACES
1.	Cutter Drive Spindle	40 Hours/Weekly		+Lithium MP White Grease 2125		1
2.	Cutter Deck Spindles	40 Hours/Weekly		+Lithium MP White Grease 2125		3
3.	Caster Wheel Bearing	100	Hours/Bi-Monthly	Chassis Grease		2
4.	Caster Wheel Pivot	100	Hours/Bi-Monthly	Chassis Grease		2
5.	Electric Clutch Belt Idler Arm	100	Hours/Bi-Monthly	Chassis Grease		1
6.	Cutter Drive Shaft	100	Hours/Bi-Monthly	Chassis Grease		3
7.	Cutter Belt Idler Arms	100	Hours/Bi-Monthly	Chassis Grease		2
8.	Deck Support Pivot	100	Hours/Bi-Monthly	Chassis Grease		2
9.	Deck Push Arms	100	Hours/ Bi-Monthly	Chassis Grease		2
10.	Deck Lift Bellcranks	100	Hours/Bi-Monthly	Chassis Grease		4
11.	Pump Idler Arm	100	HoursBi-Monthly	Chassis Grease		1
12.	Rear Wheel Pivot	200	Hours/Monthly	Chassis Grease		1
13.	Rear Wheel Bearings	200 Hours/Monthly		+Lithium MP White Grease 2125		1
14.	Right Hand Foot Plate Pivot	200	Hours/Monthly	Chassis Grease		1
15.	Steering Handle	200 Hours/Monthly		Chassis Grease		1
16.	Throttle Lever	200	Hours/Monthly	Chassis Grease		1
17.	Parking Brake Lever	200	Hours/Monthly	Chassis Grease		1
18.	Blade Brake Linkage Lever	200	Hours/Monthly	Chassis Grease		1
19.	Blade Brake Linkage Bellcrank	200 Hours/Monthly		Chassis Grease		1
20.	Blade Brake Control Lever	200	Hours/Monthly	Chassis Grease		1

*Lubrication may be required every 8 to 40 hours, depending on climate and environment. Apply two pumps of hand gun when lubricating these locations. DO NOT over-grease; damage to seal may occur.

+Compatible Greases: Mobilix #2 found at Mobil Service Station Ronex MP found at Exxon Service Stations

Super Lube MEP #2 & Super Stay-M #2 found at Conoco Stations Lidok EP #2 found at industrial shops

74