Scag Power Equipment SWZ52V-17KAI, SWZ52V-19KAI Engine Air Cleaner, Battery eLECTRIC Start Models

Page 33

Section 7

R

7.6 Engine Air Cleaner

A. Cleaning and/or Replacing Air Cleaner Element

For any air cleaner, the operating environment dictates the air cleaner service periods. Inspect and clean the air cleaner element after every 100 hours of operation or bi- weekly, whichever occurs first and replace the element if required.

- NOTE -

In extremely dusty conditions it may be necessary to check the element once or twice daily to prevent engine damage.

1.Remove the air cleaner cover. Set aside.

2.Remove the air cleaner and inspect.

3.Clean or replace the air cleaner and foam pre-cleaner as recommended by the engine manufacturer.

4.Replace the air cleaner cover and secure.

WARNING

Electric storage battery fluid contains sulfuric acid which is POISON and can cause SEVERE CHEMICAL BURNS. Avoid contact of fluid with eyes, skin, or clothing. Use proper protective gear when handling batteries. DO NOT tip any battery beyond 45° angle in any direction. If fluid contact does occur, follow first aid suggestions below.

BATTERY ELECTROLYTE FIRST AID

External Contact — Flush with water.

Eyes — Flush with water for at least 15 minutes and get medical attention immediately.

Internal — Drink large quantities of water. Follow with Milk Of Magnesia, beaten egg, or vegetable oil. Get medical attention immediately. In case of internal contact, DO NOT give fluids that would induce vomiting.

7.7 Battery - eLECTRIC START MODELS

WARNING

Lead-acid batteries produce flammable and explosive gases. To avoid personal injury when checking, testing or charging batteries, DO NOT use smoking materials near batteries. Keep arcs, sparks and flames away from batteries. Provide proper ventilation and wear safety glasses.

WARNING

Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to cause cancer and reproductive harm. Wash hands after handling.

A. Charging the Battery

Refer to the battery charger’s manual for specific instructions.

Under normal conditions the engine’s alternator will have no problem keeping a charge on the battery. If the battery has been completely discharged for a long period of time, the alternator may not be able to recharge the battery, and a battery charger will be required.

DO NOT charge a frozen battery. It may explode and cause injury. Let the battery warm before attaching a charger.

Whenever possible, remove the battery from the mower before charging and make sure the electrolyte covers the plates in all cells.

WARNING

BATTERIES PRODUCE EXPLOSIVE GASES. Charge the battery in a well ventilated space so gases produced while charging can dissipate.

29

Page 32 Page 34
Image 33
Page 32 Page 34
Contents OPERATOR’S Manual Remember Your Mower is only AS Safe AS the Operator Table of Contents Following Section Limited Warranty Commercial EquipmentIntroduction General InformationDirection Reference Servicing The Engine And Drive Train ComponentsSymbol Description SymbolsSafety Information Signal WordsBefore Operation considerations Operation Considerations Maintenance Considerations & storage Using a spark arrestor Install Belt COvER Before Safety and Instructional DecalsFalling HAzARD USE only Scag APPROvED Riding AttachmentsEngine SpecificationsElectrical Engine DeckCutter Deck Weights and Dimensions 36A61v ProductivityControls and Instrument Identification Operating InstructionsInitial RUN-IN Procedures Safety Interlock SystemStarting the Engine Ground Travel and SteeringEngaging the Deck Drive Cutter Blades Forward TravelReverse Travel Parking the Mower Hillside OperationAfter Operation Removing Clogged MaterialRecommendations for Mowing Moving Mower with Engine StoppedCondition Cause Cure Troubleshooting Cutting ConditionsTroubleshooting Cutting Conditions Contd Scalping Blades Hitting Parking brake adjustment AdjustmentsNeutral adjustment AdjustmentsTracking adjustment Throttle Control and Choke AdjustmentsCutter Deck Belt Adjustments Belt Alignment Adjusting Cutting HeightCustom-Cut Baffle Adjustment Blade Height AdjustmentCustom-Cut Baffle Adjustment Mounting Slot Selected 11. Clutch Air Gap Adjustment Electric clutch adjustmentMaintenance Chart Recommended Service Intervals MaintenanceLubrication Maintenance Chart Recommended Service Intervals ContdLubrication Fitting Points Checking Hydraulic Oil Level Hydraulic SystemChanging Hydraulic Oil Changing Hydraulic Oil Filter ElementEngine Fuel System Engine OilBattery eLECTRIC Start Models Engine Air CleanerCleaning and/or Replacing Air Cleaner Element Charging the BatteryJump Starting Cutter BladesBlade Inspection Blade SharpeningTires Blade ReplacementScag Approved Attachments and Accessories Illustrated Parts ListCaster Assembly 36A Cutter Deck 23A 462030 48V & 52V Cutter Decks 48V & 52V Cutter Decks 61V Cutter Deck 04040-04 Flatwasher, 5/16 Engine Deck Manual Start 16KAI 17KAI 19KAI Engine Deck Electric Start Battery Not Available Through Scag Drive and Brake Components 04001-151 Bolt, Hex Head 3/8-16 x Handle Assembly 16 Small Frame 461965 Handle Assembly 20 Large Frame 48798 Hydraulic Assembly Screw, 1/4-20 x 2.0 Round Head Phillips Hydraulic Pump Assembly Housing Kit 15 HP, 16 HP & 17 HP 15 HPHandle Wiring Harness Kawasaki Electric Start Wire Harnesses Wire Harness Adapter Kawasaki Replacement Decals and Information Plates Heavy-Duty Commercial Cutting Height Adjustment Limited Warranty Commercial Equipment Garantía Limitada Equipo Comercial Opcionales ARTÍCULOS/ACCESORIOS Transmisión DE Sistema Técnicas EspecificacionesCorte DE Condiciones LAS EN Fallas DE Identificación Trayectoria la de ancho Corte deLo a inclinadas Salientes IrregularDe trayectorias entre CorteCortar sin césped De Franjas VetasMáquina LA DE Limpieza PrecauciónContinuación Hidráulico Sistema Eléctrico Arranque DE Unidades Sólo BateríaNota Hidráulico SistemaMantenimiento Y Lubricación Dirección DE Control Alineación DE AjusteAlineación DE Ajuste Cualquier Realizar DE Tratar DE Antes ContinuaciónNeutral Ajuste .12 Figura Neutral AjusteCorte de deflector del Posición .9 Figura Continuacion Corte DE CuchillasCorte DE Cuchillas Corte DE Altura LA DE AjusteCorte DE Plataforma LA DE Ajustes Precaución Está motor el Si .necesario sea según Estrangule Cortacésped DEL OperaciónHoras 10 Aproximadamente Cortacésped DEL OperaciónUSO DE DÍA Primer Inicial Arranque DE ProcedimientosAlmacenamiento Mantenimiento Giratorias CuchillasOperación DE Consideraciones Operación DE ConsideracionesLA a Previas Consideraciones Operación LA a Previas Consideraciones AdvertenciaSeguridad DE General Información OperaciónLento Rápido ISO Símbolos Introducción Instrucciones DE ReferenciaScag POR Aprobados Aditamentos Y Accesorios Página Tema 21KAE-SWZSeñalización de Palabras 52V-SWM 61V-SWM21KAE-SWZ 19KAI-SWZManual DEL Operador
Top Page Image Contents