Onkyo Before Using the HT-R510, Installing the Batteries, Using the Remote Controller

Before Using the HT-R510

Installing the Batteries

1 Open the battery compartment, as shown.

2	Insert the two supplied batteries (AA/R6) in
	accordance with the polarity diagram inside

the battery compartment.

3 Close the battery compartment.

Notes:

•The supplied batteries should last for about six months, although this will vary with usage.

•If the remote controller doesn’t work reliably, try replacing both batteries.

•Don’t mix new and old batteries, or different types of bat- teries.

•If you intend not to use the remote controller for a long time, remove the batteries to prevent possible leakage and corrosion.

•Flat batteries should be removed as soon as possible to pre- vent possible leakage and corrosion.

Using the Remote Controller

To use the remote controller, point it at the HT-R510’s remote control sensor, as shown below. The HT-R510’s STANDBY indicator flashes while a signal is being received from the remote controller.

Remote control sensor

HT-R510

Standby indicator

30˚

30˚

Notes:

•The remote controller may not work reliably if the HT-R510 is subjected to bright light, such as direct sun- light or inverter-type fluorescent lights. Keep this in mind when installing the HT-R510.

•If another remote controller of the same type is used in the same room, or the HT-R510 is installed close to equipment that uses infrared rays, the remote controller may not work reliably.

•Don’t put anything, such as a book, on the remote control- ler, because the buttons may be pressed inadvertently, thereby draining the batteries.

•The remote controller may not work reliably if the HT-R510 is installed in a rack behind colored glass doors. Keep this in mind when installing the HT-R510.

•The remote controller will not work if there’s an obstacle between it and the HT-R510’s remote control sensor.

5