Onkyo HT-R510 Configuring Speaker Set A, Setting the Subwoofer Mode, Home Theater in a box HT-S760

Configuring Speaker Set A

This chapter describes how to configure speaker set A to achieve the best results from your surround sound system.

There is no speaker configuration for speaker set B.

•Before configuring, you must: —Disconnect any headphones (see page 33) —Turn off speaker set B (see page 32) —Make sure that Multich is off (see page 29)

•The HT-R510 stores each setting, so you only need to con- figure your speakers once.

SUBWOOFER PRESET/ADJUST

MODE

MASTER VOLUME

Note:

•Since some listening modes require a minimum number of speakers, when you change the above setting, the listening mode may change as well (see page 34).

Setting the Subwoofer Mode

With this function you can choose the surround channels from which the subwoofer’s output is derived.

1	SUBWOOFER	Press the [SUBWOOFER MODE]
	MODE	button once.

The current subwoofer mode is displayed.

STANDBY/ON

DIRECT	STEREO
SURROUND	DSP
PRESET/ADJUST
STANDBY

A SPEAKERS B

DISPLAY

DIMMER

DIGITAL INPUT

SUBWOOFER

MEMORY

FM MODE

TUNING

SPEAKER ADJUST

AUDIO ADJUST

MODE

CLEAR

PHONES

AUDIO

DVD

VIDEO 1

VIDEO 2

VIDEO 3

TAPE

TUNER

C D

VIDEO 3 INPUT

SELECTOR

VCR

S VIDEO

VIDEO

L AUDIO R

SPEAKER ADJUST

Specifying the Number of Speakers

With this function you can specify the number of speakers that you are using.

Home Theater in a box (HT-S760)

If you’re using all of the supplied speakers for 6.1-channel surround, you don’t need to set this function.

1	Press the [SPEAKER ADJUST]
	button.
SPEAKER ADJUST
	The current speaker configuration is dis-
	played.

2

SUBWOOFER

MODE

Press the [SUBWOOFER MODE] button repeatedly to select the fol- lowing modes:

Parameter	Description
Subwoofer	The subwoofer outputs
Mode 1	the low frequencies of all
	channels.
	The subwoofer outputs
Subwoofer	the low frequencies of the
Mode 2	center and surround
	channels only.
	The subwoofer outputs
Subwoofer	the LFE (Low Frequency
Mode 3	Effects) channel of 6.1
	source material.
	The subwoofer output is
Subwoofer	off. Choose this setting if
Off	you’re not using a sub-
	woofer, or want to turn off
	your subwoofer.

2	Use the PRESET/ADJUST [ ] [ ]
	buttons to specify the number of
	PRESET/ADJUST
	speakers.
	Front left	Center Front right

Surround left Surround right

Surround back

The available settings are shown below.

6 speakers

5 speakers

4 speakers

3 speakers

2 speakers

If you don’t press the [SUBWOOFER MODE] button for three seconds, the pre- vious display reappears.

Note:

•If you use Mode 2 or Mode 3 with the Stereo listening mode, your subwoofer may produce no sound when you play material in certain surround formats, including 2-channel Dolby Digital, DTS, etc.

25