Configuring Speaker Set
CABLE/SAT
CD/DVD
| CH + |
| |
CH SEL | LEVEL | / | |
TEST | |||
|
| ||
| VOLUME | / |
Adjusting Individual Speaker Volume
With this function you can adjust the volume of each individ- ual speaker so that you can hear all speakers equally at the listening position.
Note:
You cannot use this function while the
1 | Press the remote controller’s |
| |
| [TEST] button, and turn up the vol- |
| ume so that you can hear the test |
| tone sufficiently. |
| While each speaker outputs the test tone |
| (pink noise), its name appears on the dis- |
| play, as shown. |
2 | Use the remote controller’s |
| |
| [CH SEL] button to select each |
| speaker, and use the LEVEL [ ] [ ] |
| buttons to adjust the volume. |
Speakers are selected in the following order: Left → Center → Right → Surr Right → Surr Back → Surr Left → Sub- woofer.
You can adjust the volume of each speaker from
Notes:
•Only speakers that are included in the current configuration output the test tone. See “Specifying the Number of Speakers” on page 25.
•The subwoofer will not output the test tone if it’s off. See “Setting the Sub- woofer Mode” on page 25.
•If you don’t press any buttons for two seconds, the next speaker is selected automatically.
3 | When you’ve adjusted each |
| |
| speaker, press the remote control- |
| ler’s [TEST] button. |
| The test tone stops and the previous dis- |
| play reappears. |
Note:
If no adjustments are made for two minutes, this function is cancelled automatically and the previous display reappears.
27