Infinity OVTR 1 owner manual Installing Feet and Grilles, Ovtr

VERTICAL PLACEMENT...

Figure 4. This illustration shows how to install a molded foot for the vertical placement of a Compositions Overture OVTR 1 speaker.

INSTALLING FEET AND GRILLES

Compositions Overture OVTR 1 speakers include two types of feet for vertical or horizontal placement on a shelf, table, or speaker stand.

To insure proper woofer firing, temporarily position the speakers so that the woofer grilles face each other. On each molded foot, peel the backing from the self-adhesive tape and press each foot into its respective slot, as shown in Figure 4. Insert a grille into each speaker, so the logo is nearest the foot. Flip each speaker over and place them in your system.

❶ Peel Backing From Tape	MOLDED FOOT
(on top of foot).	(bottom view)

OVTR 1

(vertical rear views with woofers facing each other)

		CAUTION:	ATTENTION:
		MAX	50Hz	MAX
BASS			-230V	150W
		MIN	FUSE	1.6A 250V
			ON / STANDBY
	–
8 Ω INPUT			+
	+		8 Ω	INPUT
			–
	ON / STANDBY
1.6A 250V	FUSE	MIN			❷ Place Foot Into Slot And Firmly
MAX	50Hz	MAX	BASS		Press Against Speaker Bottom.
150W	-230V
	ATTENTION:	CAUTION:

HORIZONTAL PLACEMENT...

Place two small self-adhesive feet on each speaker bottom, as shown in Figure 5. Depending on where you plan to put the speaker (e.g., TV top), place two large self-adhesive feet 4 to 6 inches away (refer to Figure 5). Insert a grille into each speaker, so the logo is nearest the foot. Flip each speaker over and place them in your system.

Figure 5. This illustration shows how to install self-adhesive feet for the horizontal placement of a Compositions Overture OVTR 1 speaker.

OVTR 1

(horizontal side view woofer on top)

side-firing

woofer

OVTR 1

(bottom view)

❸Place Large Feet Here.

place large feet 4"~ 6" away from small feet

Shelf

❷ Place Small

Feet Here.

❶ Peel Backing From (2) Large And

(2) Small Self-Adhesive Feet.

5 ◆ Compositions Overture OVTR 1 – Owner’s Manual