Infinity OVTR 1 owner manual Operating the System, Bass Control Ovtr

Page 8

IMPORTANT!

IMPORTANT!

POWER ON...

CHECKING PLAYBACK...

OPERATING THE SYSTEM

For your convenience, the system is fitted with a power on/off switch. Once the system is turned on, it will automatically go into a standby mode. Once an audio signal is present, the system will automatically turn on. It will revert to standby (drawing only 7 watts) when audio is absent for a minimum of 90 minutes. A dual-color “Power On” LED (see Figure 8 below) glows red when the amplifier is in the standby mode and green when the amplifier is on.

If you plan to leave for an extended period of time (e.g., vacation), switch the system off (or unplug the AC power cord).

This product is designed for (USA) 120 Vac use only. Do not connect it to any other line voltages.

This product is fitted with a 3-prong grounded power cord. Do not use without ensuring the outlet is grounded.

1.After speaker wiring has been completed, connect each speaker’s AC power cord to the nearest AC receptacle. You should see an LED illuminate, indicating the amplifier is on (see Figure 8 below). If not, verify the AC outlet is delivering power or refer to Troubleshooting on page 9.

2.Check the speakers for playback by first setting the audio system volume control for a minimum level, and then applying power to your system. Play a favorite music or video segment and increase the volume control to a comfortable level.

NOTE: You should hear balanced audio reproduction across the entire frequency spectrum. If not, check all wiring connections and refer to the “Troubleshooting” section on page 9 for more help.

Figure 8. Located on each OVTR 1’s rear panel are a BASS level control and a dual-color “Power On” LED.

MAXMIN

More

Less

Bass

Bass

BASS CONTROL

OVTR 1

OVTR 1

(rear view)

MAX

MIN

 

 

 

 

CAUTION:

 

 

 

 

FOR CONTINUED PROTECTION

 

 

 

 

 

 

AGAINST RISK OF FIRE, REPLACE

 

 

 

 

 

 

ONLY WITH SAME TYPE OF FUSE:

 

 

 

 

 

 

2AG SB 250V

 

8 Ω +

ON /

 

-230V 50Hz

ATTENTION:

BASS

STANDBY

FUSE

UTILSER UN FUSIBLE DE RECHANGE

 

 

INPUT

 

1.6A 250V

150W MAX

DE MEME TYPE ET CALIBRE

ON / STANDBY

Power On

Standby

is green

is red

“POWER ON” LED

OVTR 1

7 Compositions Overture OVTR 1 – Owner’s Manual

Image 8
Contents Model Ovtr Ovtr Introduction Unpacking the SpeakersPlanning Your System Planning Your System Cont ’D Installing Feet and Grilles OvtrWiring the System Operating the System Bass Control OvtrOperating the System Cont ’D Replacing the FuseTroubleshooting Care of Your Speaker SystemSpecifications Ovtr DimensionsLimited FIVE-YEAR Warranty Who is protected by the warranty?
Related manuals
Manual 13 pages 28.54 Kb

OVTR 1 specifications

Infinity OVTR 1 is a cutting-edge electric vehicle that represents a significant advancement in sustainable automotive technology. Designed with the modern driver in mind, this vehicle seamlessly combines performance, efficiency, and comfort, making it an attractive choice for those looking to embrace the future of transportation.

One of the standout features of the Infinity OVTR 1 is its impressive electric powertrain. The vehicle is equipped with a high-capacity battery that provides an extensive driving range, allowing users to travel long distances without the need for frequent recharging. The advanced electric motors deliver instant torque, resulting in rapid acceleration and a thrilling driving experience. This powertrain not only maximizes performance but also minimizes environmental impact, aligning with the growing demand for eco-friendly vehicles.

The Infinity OVTR 1 incorporates cutting-edge technologies that enhance both safety and convenience. Its advanced driver-assistance systems include adaptive cruise control, lane-keeping assist, and automated emergency braking, all designed to provide a safer driving experience by minimizing the risk of accidents. The vehicle's intelligent navigation system offers real-time traffic updates and route optimization, ensuring drivers can travel efficiently and reach their destination on time.

The interior of the Infinity OVTR 1 is designed with a focus on comfort and usability. Premium materials and ergonomic seating create an inviting atmosphere, while the spacious cabin provides ample legroom for all passengers. The state-of-the-art infotainment system features a large touchscreen interface that integrates seamlessly with smartphones, providing access to navigation, music, and communication features, all at the driver’s fingertips.

Connectivity is a key characteristic of the Infinity OVTR 1, with built-in Wi-Fi capabilities allowing passengers to stay connected on the go. The vehicle is also compatible with various smart home devices, enabling users to control their home environment directly from the car. Additionally, the vehicle supports over-the-air software updates, ensuring it remains at the forefront of technology and performance enhancements throughout its lifespan.

In summary, the Infinity OVTR 1 is a remarkable electric vehicle that blends sustainable technology with luxurious features. With its impressive driving range, advanced safety systems, high-tech connectivity options, and comfortable interior, it stands out as a premier choice for environmentally conscious drivers seeking both performance and sophistication in their automotive experience. As automotive technologies continue to evolve, the Infinity OVTR 1 exemplifies the potential of electric vehicles in transforming how we think about transportation.