®
ELECTRIC POLE TRIMMER
CLEANING AND MAINTENANCE
WARNING: Disconnect Pole Trimmerfrompowersupplybefore cleaning or servicing. Severe in- juryordeathcouldoccurfromfire, electrical shock, or body contact with moving cutter blades.
WARNING: When cleaning Pole Trimmer:
•Do not submerse Pole Trimmer in any liquids
•Do not use products that con- tain Ammonia, Chlorine, or abrasives
•Donotusechlorinatedcleaning solvents,CarbonTetrachloride, Kerosene, or Gasoline.
Use a soft cloth dampened with a mild soap and water mixture to wipe Pole Trimmer pole, housing, and cutter blades clean. Do not spray or pour water directly onto Pole Trimmer.
Once the Pole Trimmer is cleaned, apply a light coat of oil to the cutter blades to prevent rust and provide lubrication (motor oil is preferred).
TROUBLESHOOTING
Note: For additional help, visit our technical service web site at www.de- satech.com.
WARNING: Unplug Pole Trimmer from power source before servicing. Severe injury or death could occur from fire, electrical shock, or body contact with moving blades.
OBSERVED FAULT | POSSIBLE CAUSE | REMEDY | ||
Motor does not run when you squeeze trig- | 1. | Trigger lock button not pressed to release | 1. | Push lock button forward and squeeze |
ger lever |
| trigger lever |
| trigger lever (see Starting the Pole Trim- |
|
|
|
| mer, page 5) |
| 2. | Extension cord connection is loose | 2. | Check cord connections |
| 3. | Household circuit breaker is tripped or | 3. | Check circuit breaker or line fuse |
|
| open line fuse |
|
|
| 4. | Bad motor brushes | 4. | Call for Technical Service |
| 5. | Open wiring on Pole Trimmer | 5. | Call for Technical Service |
|
|
| ||
Motor runs, but cutting blades do not move | Pole Trimmer damaged. Do not use Pole | Call for Technical Service | ||
| Trimmer |
|
| |
|
|
| ||
Pole Trimmer smokes during operation | Pole Trimmer damaged. Do not use Pole | Call for Technical Service | ||
| Trimmer |
|
| |
For more information, visit www.desatech.com | 8 | 110939 |