RedMax HEZ2450S manual Emission Warranty Parts List, What is not Covered, ADD-ON or Modified Parts

Page 19

HEZ2450S/HEZ3050S

warranty is warranted for the remaining warranty period. Any warranted part that is scheduled only for regular inspection in the maintenance schedule will be warranted for a period of two years. A statement in such written instructions to the effect of "repair or replace as necessary" will not reduce the period of warranty coverage. Any such part repaired or replaced under warranty will be warranted for the remaining warranty period.

DIAGNOSIS The owner must not be charged for diagnostic labor that leads to the determination that a warranted part is in fact defective, provided that such diagnostic work is performed at a warranty station.

CONSEQUENTIAL DAMAGES RedMax is liable for damages to other engine components proximately caused by a failure under warranty of any warranted part.

EMISSION WARRANTY PARTS LIST

1.Air-induction system*

2.Fuel system*

3.Ignition system*

4.Fuel tank, cap and lines as applicable*

*some components only covered up to point specified by maintenance schedule

WHAT IS NOT COVERED

All failures caused by abuse, neglect or improper maintenance are not covered.

ADD-ON OR MODIFIED PARTS

Add-on or modified parts that are not exempted by CARB or EPA may not be used. The use of any non- exempted add-on or modified parts will be grounds for disallowing a warranty claim. RedMax will not be liable to warrant failures of warranted parts caused by the use of a non-exempted add-on or modified part.

HOW TO FILE A CLAIM

If you have any questions regarding your warranty rights and responsibilities, you should contact your nearest authorized servicing dealer or contact RedMax at 1-800-291-8251 or via e-mail at service@redmax.com.

WHERE TO GET WARRANTY SERVICE

Warranty services or repairs are provided through all RedMax authorized servicing dealers.

MAINTENANCE, REPLACEMENT AND REPAIR OF EMISSION-RELATED PARTS

Any replacement part may be used in the performance of any warranty maintenance or repairs and must be provided without charge to the owner. Such use will not reduce the warranty obligations of the manufacturer.

MAINTENANCE STATEMENT

The owner is responsible for the performance of all required maintenance, as defined in the operator's manual.

U S

US-19

Image 19
Contents HEZ2450S HEZ3050S Contents Parts location SpecificationsEmission Control Symbols on the machineManufactured For safe operation Before use Using the productStarting the engine Storage Fuel safetyMaintenance TransportDisposal SE2 Set upMounting Other Parts SE1 Screw Clamp bolt Tightning Torque 70~130 in-lb 8~15 N.mGasoline Requirements WarrantyFuel FuelFor Your Engine LIFE, Avoid HOW to MIX Fuel Recommended Mixing Ratio Gasoline 50 OILFueling the Unit Operation Stopping Engine OP4 OP8 HOW to USEAdjusting Throttle Cable Adjusting Idling Speed OP7Maintenance Chart MaintenanceSpark Arrester MA1 AIR FilterMuffler MA4MA8 Procedures to be Performed After Every 100 Hours of USEMA6 Blade MA6 Intake AIR Cooling VentCase 1. Starting failure Troubleshooting guideStorage DisposalWhat is Covered Manufacturers Warranty CoverageOwners Warranty Responsibilities Warranty Commencement DateWhere to GET Warranty Service Emission Warranty Parts ListWhat is not Covered HOW to File a Claim