
HEZ2450S/HEZ3050S
9. Maintenance
WARNING
•Make sure that the engine has stopped and is cool before performing any service to the machine. Contact with moving cutting head or hot muffler may result in a personal injury.
MA1 | ■ AIR FILTER | |
• The air filter, if clogged, will reduce the | ||
| ||
| engine performance. Check and clean | |
| the filter element. If the element is |
■MUFFLER
WARNING
• Inspect periodically, the muffler for
U
loose fasteners, any damage or
S
corrosion. If any sign of exhaust leakage is found, stop using the machine and have it repaired immediately.
•Note that failing to do so may result in the engine catching on fire.
broken or clogged, replace with a new |
one. (MA1) |
(1) (1) air filter
MA4 |
■SPARK ARRESTER
• The muffler is equipped with a spark |
arrester to prevent red hot carbon from |
flying out of the exhaust outlet. |
Periodically inspect and clean as |
necessary with a wire brush. |
MA2 |
(1) |
■FUEL FILTER
•When the engine runs short of fuel supply, check the fuel cap and the fuel filter for blockage. (MA2)
(1) fuel filter
(1) |
In the State of California it is required |
by law (Section 4442 of the California |
Public Resources Code) to equip a |
spark arrester when a gas powered tool |
is used in any forest covered, brush |
covered, or grass covered unimproved |
land. (MA4) |
MA3 |
.025 in |
0.655mm |
■SPARK PLUG
•Starting failure and
HEZ2450S: NGK CMR7H
HEZ3050S: NGK CMR7H
(1) spark arrester
■GEAR CASE
• The reduction gears are lubricated by
MA5multipurpose,
•Remove the cutter holders before installing new grease to arrange for old grease to exit. (MA6)
NOTE
• When removing and installing the |
IMPORTANT
•Note that using any spark plug other than those designated may result in the engine failing to operate properly or in the engine becoming overheated and damaged.
•To install the spark plug, first turn the plug until it is finger tight, then tighten it a quarter turn more with a socket wrench.
holder(A), use care not to allow any dirt |
and dust entering in to the gear case. |
(MA6) |
TIGHTENING TORQUE:
87~104
(9.8~11.8 N.m.)