RedMax HEZ2450S, HEZ3050S manual Set up, Mounting Other Parts SE1, SE2

Page 9

HEZ2450S/HEZ3050S

6. Set up

■MOUNTING OTHER PARTS

SE1

1. Insert the driveshaft into the clutch drum, then attach the gearbox to the shaft tube as aligning the positioning holes and fasten the screw (A). Fasten

(A)	(B)

the clamp bolt (B) firmly. (SE1)

(A)Screw

(B)Clamp bolt

(B)Tightning Torque: 70~130 in-lb (8~15 N.m)

SE2

2.Install the handle to the shaft tube and clamp at a position best for your job. (SE2)

US-9

Image 9

Contents HEZ2450S HEZ3050S Contents Parts location SpecificationsSymbols on the machine Emission ControlManufactured For safe operation Using the product Before useStarting the engine Maintenance Fuel safetyTransport StorageDisposal Mounting Other Parts SE1 Set upScrew Clamp bolt Tightning Torque 70~130 in-lb 8~15 N.m SE2Fuel WarrantyFuel Gasoline RequirementsHOW to MIX Fuel Recommended Mixing Ratio Gasoline 50 OIL For Your Engine LIFE, AvoidFueling the Unit Operation Adjusting Throttle Cable OP8 HOW to USEAdjusting Idling Speed OP7 Stopping Engine OP4Maintenance Chart MaintenanceMuffler MA1 AIR FilterMA4 Spark ArresterMA6 Blade MA6 Procedures to be Performed After Every 100 Hours of USEIntake AIR Cooling Vent MA8Storage Troubleshooting guideDisposal Case 1. Starting failureOwners Warranty Responsibilities Manufacturers Warranty CoverageWarranty Commencement Date What is CoveredWhat is not Covered Emission Warranty Parts ListHOW to File a Claim Where to GET Warranty Service