RedMax BCZ2600SW, BCZ2600SU manual  13 

Page 13

	6. Set up (BCZ2600S, BCZ2600SU)
	SE1	■ MOUNTING ENGINE (SE1)
	SE1	1.	Push the driveshaft housing toward the clutch
		1.	Push the driveshaft housing toward the clutch
			housing and rotate it by hand to check that the
			driveshaft is engaged with the gears.
		2.	Insert the driveshaft housing into the clutch
			housing until it bottoms, and align the positioning
			holes on the clutch housing and the shaft tube
			and install the screw. When difficult to engage,
			twist the engine slightly.
		3.	Fasten the clamp securely with two screws.
	SE2

IMPORTANT

Tighten the screws gradually by turns.

■CONNECTING THROTTLE WIRE

1. Remove the air cleaner cover.

2. Connect the end of the throttle wire to the joint on the top of the carburetor. (SE2)

SE3

(1)

SE4

(1)

(2)

(3)

■CONNECTING SWITCH WIRES

•Connect the switch wires between the engine and the main unit. Pair the wires of the same color.

■INSTALLING HANDLE

•Mount the handle to the shaft tube and clamp it at a location that is comfortable to you. (SE3)

(1) About 19 inches (48cm)

■INSTALLING DEBRIS GUARD

•Put the debris guard on the gear box, attach it with the 4 screws and hardware provided. (SE4)

(1)debris guard

(2)plate

(3)screw

13 

Image 13

Contents BCZ2600SU BCZ2600SWPage Contents Safety FirstParts location Specifications 4   5   6  Symbols on the machineWorking Condition For safe operationWorking Circumstance  7  8  Working PlanStarting the Engine Before Starting the Engine 9   10  Using the ProductIf Someone Comes MaintenanceHandling Fuel  11  12  Transportation 13  SE6 SE5SE7 SE8 SE9 Mounting Engine SE5 Putting on Waist PADInstalling Cutting Head SE10 Set upBalance Unit  15 Fuel HOW to MIX Fuel 16  Recommended Mixing Ratio Gasoline 50OILFor Your Engine LIFE, Avoid Fueling the UnitOP1 OperationStarting Engine OP4 19  OP7 Adjusting the Line Length 20  Maintenance Chart MaintenanceMA1 Refilling Trimming Line MA1  21  22  Spark Arrester MA5 MA6 MufflerGear Case MA6 Intake AIR Cooling VentMA8 Procedures to be Performed After Every 100 Hours of USE 24   25  Storage 26  Optional blade usageBCZ2600SU OPT4 OPT3BCZ2600SU OPT5 OPT6 Cutting Method 28  OPT7 OPT8Operation Controlling Blade Bounce 29  What causes kick outTransporting the Unit OPT9 Maintenance Blade 30  Check Probable Causes Action Troubleshooting guide 31   32   33  Parts list 34   35  Optional Blade & Accessories 36  Drive Unit BCZ2600SW S/N 300001 and up 37  Optional Blade 38   39  BCZ2600S S/N 300101 and up BCZ2600SU S/N 300101 and upManufacturer’s warranty coverage RedMax 2-YEAR Limited Warranty RedMax Garantie limitée à 2 ans Page Komatsu Zenoah America INC