RedMax BCZ2600SW, BCZ2600SU manual  19 

Page 19

8. Operation

OP5

.04 in

(1~2mm) (1)

OP6

(1)

STOPPING ENGINE (OP3)

1.Release the throttle lever and run the engine for a half minute.

2.Shift the ignition switch to the STOP position.

IMPORTANT

Except for an emergency, avoid stopping the engine while pulling the throttle lever.

ADJUSTING THROTTLE CABLE

The normal play is 1 or 2mm when measured at the carburetor side end. Readjust with the cable adjuster as required. (OP5)

(1) cable adjuster

ADJUSTING IDLING SPEED (OP6)

1.When the engine tends stop frequently at idling mode, turn the adjusting screw clockwise.

2.When the cutting head keeps rotating after releasing the trigger, turn the adjusting screw counter-clockwise.

(1) idle adjusting screw

NOTE

Warm up the engine before adjusting the idling speed.

CUTTING WORK (LINE HEAD USAGE)

WARNING

1.Always wear eye protection such as safety goggles. Never lean over the rotating cutting head. Rocks or other debris could be thrown into eyes and face and cause serious personal injury.

2.Keep the debris guard in place at all times when the unit is operated.

TRIMMING GRASS AND WEEDS

Always remember that the TIP of the line does cutting. You will achieve better results by not

19

Image 19
Contents BCZ2600SU BCZ2600SWPage Contents Safety FirstParts location Specifications 4   5   6  Symbols on the machine 7  For safe operationWorking Condition Working Circumstance 8  Working PlanStarting the Engine Before Starting the Engine 9   10  Using the Product 11  MaintenanceIf Someone Comes Handling Fuel 12  Transportation 13  Putting on Waist PAD SE5SE6 SE7 SE8 SE9 Mounting Engine SE5 15  Set upInstalling Cutting Head SE10 Balance UnitRecommended Mixing Ratio Gasoline 50OIL HOW to MIX FuelFuel  16 For Your Engine LIFE, Avoid Fueling the UnitOP4 OperationOP1 Starting Engine 19  OP7 Adjusting the Line Length 20   21  MaintenanceMaintenance Chart MA1 Refilling Trimming Line MA1 22  Intake AIR Cooling Vent MA5 MA6 MufflerSpark Arrester Gear Case MA6MA8 Procedures to be Performed After Every 100 Hours of USE 24   25  Storage 26  Optional blade usageCutting Method OPT3BCZ2600SU OPT4 BCZ2600SU OPT5 OPT6Controlling Blade Bounce OPT7 OPT8 28  Operation 29  What causes kick outTransporting the Unit OPT9 Maintenance Blade 30  Check Probable Causes Action Troubleshooting guide 31   32   33  Parts list 34   35  Optional Blade & Accessories 36  Drive Unit BCZ2600SW S/N 300001 and up 37  Optional Blade 38   39  BCZ2600S S/N 300101 and up BCZ2600SU S/N 300101 and upManufacturer’s warranty coverage RedMax 2-YEAR Limited Warranty RedMax Garantie limitée à 2 ans Page Komatsu Zenoah America INC