6.Set up (BCZ2600SW)
SE5 |
SE6 |
SE7
SE8
(1)
(2)
SE9
■MOUNTING ENGINE (SE5)
1.Push the driveshaft housing toward the clutch housing and rotate it by hand to check that the driveshaft is engaged with the gears.
2.Insert the driveshaft housing into the clutch housing until it bottoms, and align the positioning holes on the clutch housing and the shaft tube and install the screw. When difficult to engage, twist the engine slightly.
3.Fasten the clamp securely with two screws.
IMPORTANT
Tighten the screws gradually by turns.
■INSTALLING HANDLE
•Mount the handle to the shaft tube and clamp it at a location that is comfortable to you. (SE6)
(1) About 14.5 inches (37cm)
■CONNECTING THROTTLE WIRE
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the top of the carburetor. (SE7)
■CONNECTING SWITCH WIRES
•Connect the switch wires between the engine and the main unit. Pair the wires of the same color. (SE7)
■PUTTING ON WAIST PAD
•Wrap the waist pad around the shaft tube and the throttle wire. (SE8)
(1)Waist Pad
(2)Band
■INSTALLING DEBRIS GUARD
•Put the debris guard on the gear box, attach it with the 4 screws and hardware provided. (SE9)
(1)Debris guard
(2)Plate
(3)Washer
(4)Screw