IR Enable / Disable
This menu item allows you to set whether the IR information received at the VSC is sent to the
To change the IR setting, turn the knob when "Ir" is displayed. Turn the knob, clockwise or counterclockwise, to switch between "On" and "FF". This setting must be performed at the VSC in each zone and is applicable to that particular zone.
After modifying the IR setting, pressing the knob once again will advance to the IR Passthrough menu item, and the display will change to "IP".
IR Passthrough Enable / Disable
This menu item allows you to select whether IR information from the remote is routed directly to the source. This will allow you to remotely control a connected audio source from any zone.
To change the IR Passthrough setting, turn the knob when "IP" is displayed. Turn the knob, clockwise or counterclockwise, to switch between "On" and "FF". This setting must be performed at the VSC in each zone and is applicable to that particular zone.
After modifying the IR Passthrough setting, pressing the knob once again will advance to the IR Passthrough menu item, and the display will change to "PG".
Setting Paging Volume
This menu item allows you to set the paging volume for the zone. Thus, when the Page input is activated, Source 6 will act as the input source and audio is transmitted at this volume setting.
To change the Paging Volume setting, turn the knob when "PG" is displayed. To increase the volume from 00, you must turn the knob clockwise until the desired volume is displayed. The maximum volume value is 99. To decrease the volume, turn the knob counterclockwise.
This setting must be performed at the VSC in each zone and is applicable to that particular zone.
Page 7