Maintenance
■SPARK PLUG
•The spark plug may gather carbon deposits on its firing end with reasonable use. Remove and inspect the spark plug every 25 hours and clean the electrodes as necessary with a wire brush. The spark gap should be adjusted to .024~.028 in. (0.6~0.7mm).
•Plug manufacturers recommend replacing the plug twice a year to avoid unexpected plug failure in a job.
REPLACEMENT PLUG IS A NGK BPMR7A.
IMPORTANT
•Note that using any spark plugs other than those designated may result in the engine failing to operate properly or in the engine becoming overheated and damaged.
•To install the spark plug, first turn the plug until it is finger tight, then tighten it a quarter turn more with a socket wrench.
■MUFFLER
WARNING
•Inspect periodically the muffler for loose fasteners, any damage or corrosion. If any sign of exhaust leakage is found, do not use the blower and have it repaired immediately.
•Note that failing to do so may result in the engine catching on fire.
IMPORTANT
•Before starting operation, always make sure to check if the muffler is properly held by two bolts to the cylinder. (Fastening Torque : 70~110kg·cm)
•Even if one bolt out of two bolts is loose,
the muffler may get loose during operation which may result in engine catching on fire.
■SPARK ARRESTER
•The muffler is equipped with a spark arrester to prevent red hot carbon from flying out of the exhaust outlet. Periodically inspect and clean as necessary with a wire brush. In the State of California it is required by law (Section 4442 of the California Public Resources Code) to equip a spark arrester when a gas powered tool is used in any forest covered, brush covered, or grass covered unimproved land.
■AIR INLET SCREEN IMPORTANT
•Blowing air is taken in from the air inlet screen. When air flow has dropped down during operation, stop the engine and inspect the air inlet screen for blocking by obstacles.
•Note that failure to remove any such obstacles may result in the engine becoming overheated and damaged.
WARNING
•Never use the blower without the screen at the air intake of the blower.
13