RedMax HEZ2650F manual Operation

HEZ2650F

8. Operation

The RedMax stick edgers are designed	■ STARTING ENGINE
for edging lawn in gardens, parks,
roadsides and so on.		WARNING
Before starting the engine, take the
operating position and adjust the handle	The cutting head will start rotating
position and the wheel height as	upon the engine starts.
necessary.

OP1

■ADJUSTING WHEEL HEIGHT

1. Loosen the wing nut and change the

wheel height to obtain desired cutting

depth. (OP1)

1.Rest the unit on a flat, firm place. Keep the cutting head off the ground and clear of surrounding objects as it will start rotating upon starting of the engine.

(1)

(2)

(3)

(1)Deep cut

(2)Shallow cut

(3)Wing nut

2.After adjusting the height, tighten the wing nut securely.

OP2

OP3

2.	Push the primer pump several times
	until overflown fuel flows out in the
	clear tube. (OP2)
3.	Move the choke lever to the closed

Tightening Torque:

51~68in-lbs (6~8N.m.)

WARNING

•Never adjust wheel height with the engine running.

	(1)
	(2)
	(3)
OP4
	(3)
(2)
(1)	(a)
	(b)
OP5

position. (OP3)

(1)choke lever

(2)close

(3)open

4.Set the stop switch to the "RUN" position. Place the unit on a flat, firm place. Keep the cutting head clear of everything around it. (OP4)

(1)stop switch

(2)RUN

(3)STOP

(a)lockout lever

(b)throttle trigger

5.Firmly grasp (a) and (b) with left hand, pull the starter knob quickly until engine fires. (OP4,5)

IMPORTANT

•Avoid pulling the rope to its end or returning it by releasing the knob. Such actions can cause starter failures.

6.Move the choke lever downward to open the choke. And restart engine. (OP3)

7.Allow the engine to warm up for several minutes before starting operation.

US-12