Using the Controls

	Air Controls		Air Controls
	Air Controls
		Display
Pump	Pump	Temperature	Light
Button 2	Button 1	Button	Button

Refer to the diagram above. The function of each control is explained below:

Pump Button 1: Turns the jets labeled on page 11 with boxed letters on and off. If the button is pressed once, the pump will run at the low setting. If the but- ton is pressed twice, the pump will run at the high set- ting. If the button is pressed a third time, the pump will shut off. Note: If the spa is heating or running a filter cycle, the pump will turn on at the low setting. If the pump is left on the low setting, it will automatically shut off after 2 hours. If the pump is left on the high setting, it will automatically shut off after 30 minutes.

The spa also features an automatic mode that heats and filters the water when the spa is left unattended. When the power to the spa is first turned on, or if the buttons on the console have not been pressed for longer than twenty minutes, the automatic mode will be activated. Note: To keep the filter and heat cycles from running, the power to the spa must be shut off at the breaker box.

Pump Button 2: Turns the remaining spa jets on and off. If the button is pressed once, the jets will run, pro- viding gentle hydrotherapy. If the button is pressed again, the jets will shut off. If the pump is left running, it will automatically shut off after 30 minutes.

Temperature Buttons: Control the temperature setting of the water. The temperature can be set from 80°F to

104°F. The water heats at about 1.8°F per hour with the cover on. Use a medical or other accurate ther- mometer to check the temperature of the water. Note: The word “COOL” will appear in the console display if the temperature of the water is more than 20°F cooler than the set temperature. When this happens, the heater will automatically activate to warm the water. The word “ICE” will appear in the display if the tem- perature drops below 40°F. If this happens, the pump will automatically circulate the water and warm the plumbing to keep the water from freezing.

The temperature buttons can also be used to change the filter cycle time. First, press either of the tempera- ture buttons. While the console display is flashing, press the jet button. The letters “FC” should appear in the display. Next, press the temperature buttons to select a 2-, 4-, or 6-hour filter cycle time. Then, press the jet button again. If the filter cycle time is not changed, it will default to 2 hours.

Light Button: Turns the underwater light on and off. The light automatically turns off after 4 hours.

Air Controls: Determine the amount of air flowing through the spa jets. If a control is turned counter- clockwise, the amount of air flowing through the jets will increase; if a control is turned clockwise, the amount of air will decrease. Test each of the air con- trols to determine which jets are controlled by which air control.