Draining the Pumps

To drain the hydrotherapy spa, follow the steps below: WINTER USE AND CARE

1.Using the console, adjust the temperature to the lowest setting.

2.Shut off the power to the spa, at the circuit breaker or GFCI.

3.Remove the pump access panel from the spa.

4.Pull the hose out and hold it above the waterline. Remove the cap and attach a garden hose to the drain hose. Lower the hose and drain the spa.

Cap	Drain
	Hose

5.When the spa is empty, close the valve and remove the garden hose. Re-attach the cap and return the drain hose inside the spa.

6.Re-attach the access panel.

7.Refill the spa and treat the water with chemicals (see pages 10 and 14).

After the hydrotherapy spa is drained, the jet pumps should also be drained if the spa will be stored for more than thirty days or if it may be exposed to freez- ing temperatures.

The hydrotherapy spa is designed for year-round use. If you decide to store the spa for the winter, store it in a warm, dry location. Follow the steps below to winter- ize the spa.

1.Make sure the power to the spa is turned off.

2.Drain the spa (see DRAINING THE HYDROTHER- APY SPA on the previous page and this page).

3.Remove all remaining water from the spa shell. Dry the spa shell with towels.

4.Set the air control to the lowest setting. Use a wet/dry vacuum to pull any remaining water from the system. To do this, place the vacuum nozzle over each jet, starting with the highest jet and fin- ishing with the lowest jet.

5.Set the air control on the console to the highest setting and repeat step 3.

6.Drain the pumps (see DRAINING THE PUMPS on this page). Once the water is drained from the pumps, place the vacuum nozzle over the drainage hole in the pumps and vacuum any additional water from the pumps. Note: For additional pro- tection, remove the pump/motors from the spa and store them in a climate-controlled room.

7.Clean the spa shell (see page 13).

8.Clean the filter (see page 13).

9.Shut the power off at the breaker. Label the breaker in such a way that the breaker will not be turned on accidentally.

10. Re-attach the access panel and the spa cover.

REPLACING THE LIGHT BULB

If the underwater light burns out, you will need to remove the pump access panel to replace it (see

ATTACHING AND REMOVING THE ACCESS PANEL on page 14). Make sure the spa power is turned off. Next, locate the light housing. Turn the light housing counterclockwise and remove it from the spa shell.

Turn off the power to the spa. To drain the jet pumps, remove the access panel from the spa unit (see ATTACH-

ING AND REMOVING THE ACCESS PANEL on page 14). Locate the jet pumps inside the spa. Loosen the indicated collar on each of the pumps.

Collar

Light Housing	Light
	Bulb

Light

Housing

To replace the light bulb, pull the old light bulb out of the housing and insert a new light bulb. Re-attach the light housing to the spa shell. Re-attach the access panel to the spa.