ProForm PFHS70071 manual Maintenance

Filter

Filter

Housing

MAINTENANCE

The RESTORATION 2.0 is designed to provide you with years of enjoyment. Please follow the guidelines below to properly maintain your spa.

MAINTENANCE SCHEDULE

DAILY

¥Check the water level and refill the spa to the level shown on page 8, step 1.

¥Check the pH balance and sanitizer level. Adjust if necessary (see WATER CHEMISTRY on this page).

WEEKLY

¥Clean the spa shell at the waterline.

¥Check and thoroughly clean the filter (see CHECK- ING AND CLEANING THE FILTER on this page).

¥Replace the filter if needed (see ORDERING REPLACEMENT PARTS on the back cover).

MONTHLY

¥Clean the spa cover (see MAINTAINING THE SPA COVER below).

¥Soak the filter for two hours in a trisodium phos- phate (TSP) solution. Rinse the filter in clean water.

¥Replace the filter if needed (see ORDERING REPLACEMENT PARTS on the back cover).

EVERY THREE MONTHS

¥Drain the spa and refill with clean water. Sanitize and test the pH of the water.

¥Check for any leaks around the pump or joints in the pipes. The seals will wear out over time; detect- ing leaks early can reduce repair costs.

¥Clean the interior of the spa. Do not use solvents or waxes.

EVERY SIX MONTHS

¥Treat the exterior with a wood sealant (see MAIN- TAINING THE SPA EXTERIOR below).

MAINTAINING THE SPA COVER

The spa cover should be cleaned monthly. To clean the spa cover, hang it over a clothes line and spray it with a hose. Allow the cover to dry thoroughly.

CLEANING THE SPA SHELL

The spa shell should be cleaned with a mild soap solution. Do not use solvents. The spa should always be clean and dry before being moved or stored.

MAINTAINING THE SPA EXTERIOR

The wood panel exterior has been treated with a sealant at the factory to protect the wood from water

damage. We suggest that you treat the wood finish twice a year with an additional coat of weather sealant. Contact you local spa and pool supplier for advice on which sealants work best in your climate.

CHECKING AND CLEANING THE FILTER

The filter should be checked periodically for build-up of dirt and oil. If the filter needs to be cleaned, follow the steps below:

1.Turn off the power.

2.Remove the two screws from the filter cover. Be careful not to strip the threads from the holes.

Remove the Filter Cover.

3.Remove the filter

from the spa jet	Screws
unit by lifting the
filter from the fil-	Filter
ter housing.
	Cover

4.Check the filter for any dirt or debris. If the filter

needs to be cleaned, rinse the filter with a hose. If the filter still is dirty, you will need to soak it in a cleaning solu- tion which can be obtained from a pool and spa supply store.

5. Inspect the filter for damage.

Replace the filter if there are any signs of dam- age.

6.Re-insert the cleaned filter into the filter housing.

7.Re-attach the filter cover with the screws. Do not overtighten the screws.

SANITIZING THE RESTORATION 2.0

Please refer to your local pool and spa supplier for information concerning which chemicals you should use in your area to sanitize the spa.

The most common sanitizing agent is a solid bromine concentrate. The amount required varies according to several factors, such as user load, temperature, water conditions, and so forth.

Proper water maintenance is a fairly complex process. We recommend that you contact your local pool and spa supplier for information on how you should best accomplish this.

13