ProForm 831.210051 manual SPA Shell Diagram SPA Operation

Page 13

SPA SHELL DIAGRAM

G

A

C

A

B

E F

D

B

B

A

D

AA

SPA OPERATION

Refer to the diagram above. The function of each component is explained below:

The eight uni-directional thera-jets (A) are located on both sides of the spa. Five jets focus the water massage on your upper or lower back. The remaining three jets provide a foot hydro-massage for three of the seating positions.

The six multi-directional thera-jets (B) can be adjusted for a custom hydro-massage. Each thera-jet can also be shut off by being pressed in and turned back on by pulling the jet back out. Two of the jets are located on the reclining seat and focus the water massage on your lower back. Two more jets are locat- ed on each of the bench seats, and focus the water massage on your lower or middle back.

The filter (C) can be removed for replacement and cleaning (see CHECKING AND CLEANING THE FIL- TER on page 19).

The suction vents (D) located near the floor of the spa brings the water into the pump in order to operate the system. The suction covers should always be in place over the suction vents. Never operate the spa without the suction covers in place.

This spa is ozone ready. An optional ozone generator can be installed to utilize the ozone jet (E). Ozone provides a way to help sanitize your spa with minimal chemical treatment.

The temperature probe (F) reads the current water temperature, which is displayed on the console.

The RESTORATION 5.1 also has a light (G) for your safety and convenience during evening use.

The RESTORATION 5.1 features automatic freeze protection. If the water temperature falls below 40¡F, the pump will begin circulating and heating the water to prevent the water from freezing.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Model No Serial No QUESTIONS?Customer HOT Line Mon.ÐFri., 6 a.m.Ð6 p.m. MSTLimited ONE Year Massage SPA Warranty Table of ContentsPage Page Page Before YOU Begin If you set up the hydrotherapy spa outside If you set up the hydrotherapy spa insideChoosing a Location for the Hydrotherapy SPA SET-UP and Assembly Page Wiring the Restoration Access Cover Testing and Treating the Water Using the Hydrotherapy SPAStarting the Hydrotherapy SPA Securing the SPA CoverSPA Shell Diagram SPA Operation Console Diagram Using the Console Posting the Warning Sign Adjusting the Filter CycleMaintenance Water Chemistry Attaching and Removing the Access CoverMaintaining the Proper PH Balance Draining the Hydrotherapy SPAOpening and Closing the CUT-OFF Valves Draining the PumpWinter USE and Care Removing and Cleaning the Basket Checking and Cleaning the FilterRemoving and Cleaning the Filter Cartridges Adjusting the DiverterTROUBLE-SHOOTING Symptom the SPA Continues to RUN After IT has Been Shut OFF Symptom the Water Level DropsKey No. Qty Description Part LISTÑModel NoExploded DRAWINGÑModel No Model No Ordering Replacement Parts
Top Page Image Contents