Cub Cadet CC3000 manual Maintenance, Single Line Installation, Winding the Existing Inner Reel

Maintenance (continued)

Outer Spool

Spring

Inner Reel

Bump Knob	Bolt
Fig. 6-1
Indexing Teeth
Fig. 6-2

For Use with	For Use with Membrane
Single Line ONLY	Line or Single Line

Slotted

Holes

Fig. 6-3

Loop

Fig. 6-4

LINE INSTALLATION

This section covers both Membrane line and standard single line installation.

Always use manufacturer’s 0.105 inch (2.67 mm) replacement line. Line other than specified may make the engine overheat or fail.

Never use metal-reinforced line, wire, chain, or rope, etc. These can break off and become a dangerous projectile.

There are two methods to replace the trimming line.

•Wind the inner reel with new line

•Install a prewound inner reel

Winding the Existing Inner Reel

1.Hold the outer spool with one hand and unscrew the Bump Knob clockwise (Fig. 6-1). Inspect the bolt inside the Bump Knob to make sure it moves freely. Replace the Bump Knob if damaged.

2.Remove the inner reel from the outer spool (Fig. 6-1).

3.Remove spring from the inner reel (Fig. 6-1).

4.Use a clean cloth to clean the the inner reel, spring, shaft, and inner surface of the outer spool.

5.Check the indexing teeth on the inner reel and outer spool for wear (Fig. 6-2). If necessary, remove burrs or replace the reel and spool.

NOTE: Membrane line can only be used with the inner reel with the slotted holes. Single line can be used on either type of inner reel. Use figure 6-3 to identify the inner reel you have.

NOTE: Always use the correct line length when installing trimming line on the unit. The line may not release properly if the line is too long.

Single Line Installation

Go To Step 8 for Membrane Line Installation

6.Take approximately 30 feet (9.1 m) of new trimming line, loop it into two equal lengths. Insert each end of the line through one of the two holes in the inner reel (Fig. 6-4). Pull the line through the inner reel so that the loop is as small as possible.

7.Wind the lines in tight even layers, onto the reel (Fig. 6-5). Wind the line in the direction indicated on the inner reel. Place your index finger between the two lines to stop the lines from overlapping. Do not overlap the ends of the line. Proceed to step 11.

13