Simplicity 1692969, 1692963, 1692957, 1692959 Belt Replacement, Tractor Drne Belt, Mower Deck Belt

Page 29

Belt Replacement

Figure 28. PTO (Electric Clutch) Assembly

A .

P T O

C.

Washer

B.

Sleeve

D .

Capscrew

A CAUTION

To avoid damaging belts, do not pry belts over pulleys .

TRACTOR DRNE BELT

1. Park the tractor on a level surface. Disengage the

PTO, turn off the engine and set the parking brake.

-~. Remove tne key.

2. Remove the mower deck from the tractor. See Mower Installation & Removal on page 8.

3. Unplug the wiring harness from the PTO. Remove the PTO as shown in figure 28.

4. Remove the drag link rear hardware. When reassem- bling, apply Loctite to nut before tightening.

5. On gear models, disconnect the wires from the neu- tral switch on the transmission.

On hydro models, loosen the belt stop on the trans- mission pulley. Belt stop hardware is located on the inside of RH frame. Move belt stop out of the way. Belt stop should be positioned I/8” from belt when new belt is installed and hardware is tightened.

6.Carefully slide belt over transmission pulley and remove from other pulleys.

7.Install new belt as shown in figures49 & 30.

8.Reverse steps i-7..

MOWER DECK BELT

1.Park the tractor on a level surface. Disengage the PTO, turn off the engine and set the parking brake. Remove the key.

Figure 29. Drive Belt Routing - Hydro Models

A. Engine PulleyC. Idler Pulley B. Transmission Pulley

Figure 30. Drive Belt Routing - Gear Model

A. Engine PulleyC. Idler Pulley B. Transmissioin Pulley

Figure 31. Mower Deck Belt Routing

2.Remove the mower deck from the tractor. See Mower Installation & Removal in the Operation section.

3.Remove the old belt and install the new belt over the pulleys as shown in figure 31.

4.Reinstall the mower deck on the tractor.

2 5

Image 29
Contents Teamtractors Face Mask Installation Trim InstallationTractor Description Mfg. No Base Color Accent Mask Decal 81 Paint InformationFormNo. FIB /w 0 Copylight ,996 simplici~ Manf?.tiring, Inc Table Of Contents Identification Numbers Tractor & Mower IdentificationSlope Operation Safety RulesGeneral Operation Transporting and Storage Service and MaintenanceChildren General Safety DecalsControls Gear Model Features & ControlsControls Hydro Model Operation Safety Interlock SystemOperation Mower Installation & RemovalCLUTCH/BRAKE Pedal Operation Checks Before StartingParking Brake Starting the EnginePushing the TRACTOR-BY Hand Stopping the TractorHydro Model Gear ModelMowing Conditions Mulching Mower Operation Optional KIT AttachmentMulching Mowing Patterns & lips Schedule Normal CareRaising the Hood & Seat CHECKING/ADDING GasolineLubrication Checking Tire PressureChecking Fuel Filter Checking the Battery Fluid Battery MaintenanceCleaning the Battery and Cables Transaxle Hydro ModelsRemoving the Blade Servicing the Mower BladesStarting After Long Term Storage Temporary Storage 30 Days or LessLong Term Storage Longer than 30 Days Troubleshooting the Tractor Troubleshooting & RepairCharging a Completely Troubleshooting the MowerChecking the Battery Jump Starting with Auxiliary Booster Battery Troubleshooting & RepairBrake Adjustment Seat AdjustmentThis HOOK-UP for Negative Ground Vehicles Make Certain Vehicles do not TouchForward Speed AtWSTMENT- Hydro Neutral Adjustment HydroSteering Gear Adjustment Neutral Adjustment GearMower Adjustments Leveling The MowerBlade Brake Check AdjustmentsMower Deck Belt Belt ReplacementTractor Drne Belt Dimensions SpecificationsEngine Transmission GearOptional Accessories Maintenance ItemsParts PartsInternational Symbols