Normal Care
TRANSAXLE - HYDRO MODELS
The hydro transaxle is a sealed unit. The transaxle is filled with oil and does not require any further lubrication unless a service overhaul is performed
BATTERY MAINTENANCE
Checking the Battery Fluid
1.Raise the seat by tilting it forward to gain access to the battery.
A WARNING
Be careful when handling the battery. Avoid spilling electrolyte. Keep flames and sparks awav from the batterv .
2.Remove battery filler cap (C, figure 13). Fluid must be even with split ring full mark. If not, add distilled water.
3.Reinstall filler cap.
Cleaning the Battery and Cables
1.Disconnect the cables from the battery, negative cable first (B, figure 13).
Figure 13. Battery
A. Positive Battery Terminal C. Battery Cap
B. Negative Battery Terminal D. Battery Clamp
2.Remove the battety clamp (D, figure 13) then remove the battey.
3.Scrub the battey, cables and battery compartment with baking soda and water.
4.Clean the battery terminals and cable clamps with a wire brush and battery post terminal cleaner.
5.Reinstall battery and clamp.
6.Connect cables, positive cable first. Position positive cable over seat switch harness to orevent harness from becoming pinched in seat pivot.
7.Coat cable clamps and terminals with grease or petroleum jelly.
15