Simplicity 7800072 Check Tire Pressures, Checking / Adding Fuel, Fuel Filter, Engine Maintenance

Page 23

CHECK TIRE PRESSURES

Tire pressure should be checked periodically, and main- tained at the levels shown in the chart. Note that these pressures may differ slightly from the “Max Inflation” stamped on the side-wall of the tires. The pressures shown provide proper traction, improve cut quality, and extend tire life.

CHECKING / ADDING FUEL

To add fuel:

1.Remove the fuel cap.

2.Fill the tank to the bottom of the filler neck. This will allow for fuel expansion.

NOTE: Do not overfill. Refer to your engine manual for specific fuel recommendations.

3. Install and hand tighten the fuel cap.

FUEL FILTER

The fuel filter is located in the fuel line between fuel tank and fuel pump. If the filter is dirty or clogged, replace as follows:

1.Shut off the fuel valve (A, Figure 18).

2.Disconnect the negative battery cable.

3.Place a container below the filter to catch spilled fuel.

4.Using pliers, open and slide hose clamps from fuel fil- ter (B, Figure 18).

5.Remove hoses from filter.

6.Install new filter in proper flow direction in fuel line.

7.Secure with hose clamps.

8.Reconnect the negative battery cable when finished.

ENGINE MAINTENANCE

Refer to engine owners manual for all engine mainte- nance procedures and recommendations.

Regular Maintenance

 

 

Tire

Pressure

Front

25 psi (1,72 bar)

 

 

Rear

15 psi (1,03 bar)

 

 

Figure 17. Checking Tire Pressure

WARNING

Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do not allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills.

Do not remove fuel filter when engine is hot, as spilled gasoline may ignite. DO NOT spread hose clamps further than necessary. Ensure clamps grip hoses firmly over filter after installation.

Do not use gasoline containing METHANOL, gasohol containing more than 10% ethanol, gasoline additives, premium gasoline, or white gas because engine/fuel system damage could result.

A

B

Figure 18. Fuel Valve Replacement

(View looking back from battery compartment)

A.Fuel Valve

B.Fuel Filter

19

Image 23
Contents Bindery Operator’s ManualsPaper Size PressPage OPERATOR’S Manual Page Table of Contents Safety Rules & Information From Previous Safety Rules and InformationTowing CE Identification TAG Markings Identification NumbersSafety Decals Safety DecalsOperational Safety Checks Safety Interlock SystemChoke Control FunctionsMotion Control Levers Features & Controls Checks Before Starting General Operating SafetyPushing the Rider by Hand OperationStarting the Engine Stopping the Rider & EngineReverse Travel Practice Zero Turn Driving PracticeSmooth Travel Forward Travel PracticeExecuting an End-Of-Row Zero Turn Practice Turning Around a CornerRemoval Mower Removal InstallationAttaching a Trailer Installation Before Every Spring Each Hours 100 250 Fall Use Regular MaintenanceLubrication Regular MaintenanceServicing the Mower Blades Service Interval Every 10 Hours or As RequiredFuel Filter Engine MaintenanceCheck Tire Pressures Checking / Adding FuelStorage Battery MaintenanceCleaning the Battery and Cables Troubleshooting the Rider Troubleshooting, Adjustments, & ServiceTroubleshooting the Mower Troubleshooting, Adjustments, & ServiceSeat Position Adjustment Seat AdjustmentsMotion Control Lever Adjustment Speed Balancing AdjustmentRoller BAR Adjustment Motion Control Lever Friction AdjustmentCutting Height Adjustment Neutral Adjustments Brake Adjustment Parking Brake AdjustmentFront Suspension Adjustment Select Models Blade Brake Check PTO Clutch AdjustmentOrient Blades Side-to-Side Mower Deck LevelingIf Equipped Deck Timing ROD AdjustmentRoller BAR Leveling Battery Charging Transmission Drive Belt ReplacementPRY Belts Over Pulleys Mower Belt ReplacementFuse Replacement Chassis CE Compliance Specifications TransmissionsDimensions EngineTechnical Manuals Replacement PartsMaintenance Items