Normal Installation & Removal
Figure 3.
A.Grass Bag Frame
B.Support Bracket
3.Open grass bag cover and install grass bag frames (A, figure 3) to support brackets (B).
4.On 30" mower, lift the deflector (C) up and install the adapter (A, figure 4) to mower deck by hooking bracket over the rear carriage bolt and securing with jam nut (D) and positioning front slot on the adapter under wing nut (B). Secure by tightening knob and wing nut. Make sure that bottom of adapter is below stone guard.
On 34" mower, lift up deflector (C) and install the adapter by hooking rear bracket over the mower hinge rod and positioning front slot on the adapter under wing nut (B). Tighten wing nut. Make sure that bottom of adapter is below stone guard.
5.Apply dry talc to rubber seal at cover opening. Install tube (A, figure 5) as far as possible into opening to clear adapter and install over adapter. Secure by rotating wire form (B) down into locked position over puck on adapter.
6.To remove the grass catcher assembly, reverse steps 1 - 5. Make sure deflector (C, Figure 4) is in proper operating position after removal of grass catcher adapter.
Figure 4. (30” Mower Shown)
A.Adapter
B.Wing Nut
C.Deflector
D.Jam nut, 5/16-18
E.1/2” Hole
6