Initial Setup 34 Models, Install Baffle

Initial Setup - 34” Models

34" MODELS -

BAFFLE, BLADE, & ADAPTER ASSEMBLY

Install Baffle

1.Remove mower deck from rider. Position mower deck upright and support in this position.

2.Position baffle with notched end towards discharge side opening, Install all hardware as shown in figure 10. The notch must be positioned to clear the stone guard weldment.

3.Tighten all hardware at the discharge side of baffle first, then tighten hardware at the middle of baffle, and finally tighten hardware at inside location.

E D I HK

B G

Figure 10. Install Baffle - 34” Models

A.Carriage Bolt, 5/16-18 x 2-1/4

B.Cup

C.Flange Nut, 5/16

D.Wingnut Assy.

E.Centerlock Nut, 5/16

F.Carriage Bolt, 5/16-18 x 1-3/4

G.Spacer (Between Baffle & Deck)

H.Lockwasher, 5/16

I.Nut, 5/16

J.Carriage Bolt, 5/16-18 x 3/4

K.Nut, 5/16

L.Blade Tabs

M.High-Lift Blade

Install Blades -

Later Models with Hex Arbor

1.Remove existing discharge-side blade but retain hardware.

2.Install the new high-lift blade (D, figure 11a) with the tabs pointing up toward the bottom of the deck. Secure with original hardware and torque capscrew

(H) to 45-55 ft. lbs. (61-75 N.m.).

NOTE: Discard the 2" O.D. splined adapter provided with the bagger; it is not used with later model decks.

Figure 11a. Install High-Lift Blade - Later Models

A. Washer	E. Blade, 16-1/8”
B. Arbor Shaft	F. Hex Washer
C. Grass Shield	G. Spring Washer
D. High-Lift Blade	H. Capscrew