Simplicity 1692150, 1692149 instruction sheet Grass Catcher Assembly ALL Models

GRASS CATCHER ASSEMBLY - ALL MODELS

NOTE: Cover and bag support are packaged as an assembly with long clevis pins and clips. It may be easier to separate components for the following step.

1.Install horizontal bag support (A, figure 14) to upright catcher support (B) holes as shown. Note that the open set of holes (D) is toward the discharge side of mower. Install four 3/8-16 x 7/8 capscrews (C) from the front and lightly secure with flange lock nuts.

2.Make sure bag support and catcher support are square, then tighten flange lock nuts.

3.Reinstall grass catcher cover (A, figure 15) to support

(B) and secure with clevis pins (C) and clips (D).

Initial Setup - All Models

Figure 14.
A. Bag Support	C. Capscrew, 5/16-18 x 7/8
B. Catcher Support	D. Open Set Of Holes

4.Install handle (A, figure 16) to rear surface of lid with offset toward the rear. Secure with two 10-32 x 1/2 truss screws (B) and 10-32 hex nuts (C).

Figure 15.
A. Cover	C. Clevis Pin
B. Support	D. Clip

Figure 16.

A.Handle

B.Truss Screw

C.Hex Nut, 10-32

13