Simplicity 1692150, 1692149 instruction sheet Normal Installation Removal, Installation & Removal

Normal Installation &

Removal

INSTALLATION & REMOVAL

NOTE: For first-time installation, refer to Initial Setup &

Installation.

NOTE: If mower deck is equipped with Mulching Kit, the mulching baffles must be removed for grass collection. Make sure the high-lift blades (34') or high-lift tabs (30') are installed per the Assembly Instructions at the back of this manual.

1.Install the grass bag and bracket assembly (A, figure 1) on the anchor assemblies (B) located on each side of the transmission housing. Push forward so the bracket assembly rests fully on the anchors.

2.Insert the round pin (C) through the bracket assembly and frame, and secure it using the safety clip pin (D).

NOTE: If grass bag and bracket assembly is too bulky to install as one piece, separate the grass bag cover (A, fig- ure 2) from the upright support (B) by removing clips (D) and long clevis pins (C). Reinstall cover after support assembly is properly installed.

5