contacting any object. Hold the unit by hand; do not use the shoulder strap for support.
SKeep others away when making carburetor adjustments.
SUse only recommended Poulan PRO ac- cessories and replacement parts.
SHave all maintenance and service not ex- plained in this manual performed by an au- thorized service dealer.
FUEL SAFETY
SMix and pour fuel outdoors.
SKeep away from sparks or flames. S Use a container approved for fuel.
S Do not smoke or allow smoking near fuel or the unit or while using the unit.
S Avoid spilling fuel or oil. Wipe up all fuel spills before starting engine.
S Move at least 10 feet (3 meters) away from fu- eling site before starting engine.
S Stop engine and allow it to cool before re- moving fuel cap.
S Remove fuel cap slowly.
CUTTING SAFETY
WARNING: Inspect the area to be cut before each use. Remove objects (rocks, bro- ken glass, nails, wire, string, etc.) which can be thrown or become entangled in the blade or trimmer line.
SKeep others including children, animals, by- standers, and helpers at least 50 feet (15 me- ters) away. Bystanders should be encouraged to wear safety glasses. Stop engine immedi-
ately if you are approached.
SAlways keep engine on the
of your body.
SHold the unit firmly with both hands.
SKeep firm footing and balance. Do not over- reach.
SKeep blade/trimmer head below waist level. S Do not raise powerhead engine above your
waist.
S Keep all parts of your body away from spin- ning line/blade and muffler.
SCut from your left to your right. Cutting on the right side of the shield will throw debris
away from the operator.
SUse only in daylight or good artificial light. S Use only for jobs explained in this manual.
TRANSPORTING AND STORAGE
SStop the powerhead engine before carrying
unit.
SKeep muffler away from your body.
SAllow engine to cool and secure unit before
storing or transporting it in a vehicle.
SEmpty the fuel tank before storing or trans- porting the unit. Use up fuel left in the carbu-
retor by starting the engine and letting it run until it stops.
SStore unit and fuel in an area where fuel va- pors cannot reach sparks or open flames
from water heaters, electric motors or switches, furnaces, etc.
SStore unit so the blade cannot accidentally
cause injury.
SStore unit indoors, out of reach of children. If situations occur which are not covered in this manual, use care and good judgment. If you need assistance, call
SPECIAL NOTICE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnor- mal swellings. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feel- ing in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An
SAVE THESE INSTRUCTIONS
ASSEMBLY
CARTON CONTENTS
Check carton contents for the following:
SBrushcutter attachment S Handlebar
S Handlebar mounting bracket for 1″ shaft S Handlebar mounting bracket for 7/8″ shaft S Bracket cover (2)
S Shoulder strap
S Upper shoulder strap clamp
S Lower shoulder strap clamp (with spacer tabs) S Handlebar bracket screws (4)
S Shoulder strap clamp screws (2)
S
S Large nut for installing blade S Retaining washer
S Cupped washer
S Metal shield (assembled on brushcutter at- tachment)
S Trimmer head S Plastic shield
SWing nut (screwed onto plastic shield) S Attachment hanger
S Hex wrench
WARNING: If received assembled, re- peat all steps to ensure your unit is properly as- sembled and all fasteners are secure.
Examine parts for damage. Do not use dam- aged parts.
NOTE: If you need assistance or find that parts are missing or damaged, call
TOOLS REQUIRED
SHex wrench (provided)
INSTALLING BRUSHCUTTER ATTACHMENT
CAUTION: When removing or installing at- tachments, place the unit on a flat surface for stability.
4