SERVICE AND ADJUSTMENTS
REPLACING THE LINE
1.Remove spool by firmly pulling on tap but- ton.
2.Clean entire surface of hub and spool.
3.Replace with a
WARNING: Never use wire, rope, string, etc., which can break off and become a dangerous missile.
4.Insert ends of the lines about 1/2 inch (1 cm) into the small holes on the inside of spool.
Spool
Small
Holes
Line exit holes | Line in Notch |
Hub | Line in Notch |
|
5.Wind the line evenly and tightly onto the spool. Wind in the direction of the arrows found on the spool.
6.Push the lines into the notches, leaving 3 to 5 inches (7
7.Insert the lines into the the exit holes in the hub as shown in the illustration.
8.Align the notches with the line exit holes.
9.Push spool into hub until it snaps into place.
10.Pull the lines extending outside of the hub to release the lines from the notches.
TRIMMER HEAD REPLACEMENT
Refer to the ASSEMBLY section for trimmer head replacement instructions and illustra- tions.
BLADE REPLACEMENT
Refer to the ASSEMBLY section for blade re- placement instructions and illustrations.
STORAGE
WARNING: Perform the following steps after each use:
SAllow attachment and gearbox to cool be-
fore storing or transporting.
SStore attachment with blade shield in place.
Position attachment so that any sharp ob- ject cannot accidentally cause injury.
SStore the attachment in a dry, well ventilated area out of the reach of children.
SEASONAL STORAGE
Prepare attachment for storage at end of sea- son or if it will not be used for 30 days or more. If your brushcutter attachment is to be stored for a period of time:
SClean the entire attachment.
SInspect the blade shield area and clean any dirt, grass, leaves, or debris that has col- lected. Inspect the blade and blade shield; replace a blade that is bent, warped, cracked, broken or damaged in any other way.
SLightly oil external metal surfaces.
SApply a coating of oil to the entire surface of the blade; wrap it in heavy paper or cloth.
SCheck entire attachment for loose screws or nuts. Replace any damaged, worn or
broken parts.
S At the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.
13