LOWER SHOULDER STRAP | SHOULDER STRAP |
CLAMP | |
| ADJUSTMENT |
Spacer Tabs | FOR BALANCE |
|
Spacer Tabs positioned for use on 1″ (2.5 cm) diameter upper shaft
1.Place the upper shoulder strap clamp over the upper shaft above the handlebar.
2.Position the lower shoulder strap clamp under the upper shaft and align the upper and lower clamp screw holes (use spacer tabs between upper and lower clamps if necessary to secure clamp, i.e. for 1″ (2.5 cm) diameter upper shaft).
Upper Shoulder
Strap Clamp
POWERHEAD
END
Lower Shoulder | ATTACHMENT | |
END | ||
Strap Clamp | ||
Screws | ||
|
3. Insert two screws into the screw holes.
4. Secure shoulder strap clamp by tighten- ing screws with the hex wrench.
5. Insert your right arm and head through the shoulder strap and allow it to rest on your left shoulder. Make sure the danger sign is on your back and the hook is to the right side of your waist.
NOTE: A
6.Adjust the strap, allowing the hook to be about 6 inches below the waist.
7.Fasten the strap hook to the clamp and lift the tool to the operating position.
8.Try on shoulder strap and adjust for fit and balance before starting the engine or
beginning a cutting operation.
NOTE: It may be necessary to relocate the shoulder strap clamp on the shaft for proper balancing of unit.
6 inches |
|
| 4 |
(15 cm) |
| 30 inches | (10 |
below |
| (76 cm) | above |
waist |
| minimum | ground |
|
|
|
|
30inches
(76 cm) minimum
CONFIGURING YOUR UNIT
You can configure your unit using a trimmer head for grass and light weeds, or a weed blade for cutting grass, weeds, and brush up to 1/2 inch (1 cm) in diameter. To assemble your unit, go to the section for the desired configuration and follow the instructions.
ASSEMBLY INFORMATION - TRIMMER HEAD
TRIMMER
HEAD
NOTE: Remove the blade and metal shield be- fore attaching the plastic shield and trimmer head. To remove blade, align hole in the dust cup with the hole in the side of the gearbox by rotating the blade. Insert a small screwdriver into aligned holes. This will keep the shaft from turning while loosening the blade nut. Remove blade nut by turning clockwise. Remove the screwdriver. Remove both washers and blade.
6