MAINTENANCE
IMPORTANT INFORMATION
To avoid deck damage, the
|
|
| |
just slightly off of the ground when the deck is at the |
|
desired cutting height in the operating position. Anti- |
|
scalp rollers then keep the deck in the proper position |
|
to help prevent scalping in most terrain conditions. |
|
IMPORTANT INFORMATION |
|
Adjust |
|
flat level surface. |
|
The |
|
• Upper position 1½ to 2½" (38 to 64 mm) grass |
|
• Middle position 2½" to 4" (64 to 102 mm) grass |
|
• Lower position 4" to 6" (102 to 128 mm) grass. |
|
The rollers should be approximately ¼" (6.5 mm) from |
|
ground. Do not adjust the rollers to support the deck. | |
|
Caster Wheels
Check every 200 hours. Check that wheels rotate freely. If wheels do not rotate freely take the unit to your dealer for service.
Foam filled tires or solid tires will void the warranty.
Removal and installation of caster wheel
1.Remove nut and caster bolt.
2.Pull the wheel out of the yoke and take care of the spacers.
3.Install in reverse order. Tighten caster bolt.
IMPORTANT INFORMATION
DO NOT add any type of tire liner or foam fill material to the tires. Excessive loads created by foam filled tires will cause premature failures.
Only use O.E.M. specified tires.
Caster wheels
38