Husqvarna YTH2242 TF Before Starting the Engine, Service REMINDER/HOUR Meter, ADD Gasoline

Page 12

OPERATION

SERVICE REMINDER/HOUR METER

Service reminder shows the total number of hours the engine has run and flashes to indicate that the engine or mower needs servicing. When service is required, the service reminder will flash for two hours. To service engine and mower, see the Maintenance section of this manual.

NOTE: Service reminder runs when the ignition key is in any position but "STOP". For accurate reading, be sure key remains in the "STOP" position when engine is not running.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

Check engine oil with tractor on level ground.

Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

To change engine oil, see the Maintenance section in

this manual.

ADD GASOLINE

Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP ENSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

RESERVE FUEL VALVE OPERATION (See Fig. 12)

1.Raise seat to access reserve fuel valve.

2.In normal operation, valve should be set to primary (as shown in view)

3.If tractor runs out of fuel, rotate valve handle to reserve.

4.Drive tractor to be refueled.

5.After refueling, return valve to primary position.

RESERVE

FUEL VALVE

RESERVE

PRIMARY

Fig. 12

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

Be sure freewheel control is in the transmission engaged position.

Sit on seat in operating position, depress brake pedal and set parking brake.

Move attachment clutch to “DISENGAGED” position.

Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F / 10°C and above)

When engine starts, move the throttle control to the fast position.

The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F / 10°C and below)

When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast posi- tion. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

12

Image 12
Contents YTH2242 TF Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Assembly Tools Required for AssemblyUnassembled Parts ToremovetractorfromcartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor CJKHOW to USE Your Tractor Attachment Clutch Switch Disengaged EngagedTo SET Parking BRAKESee Fig Stopping See FigTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo Move Forward and Backward See Fig To USE Cruise Control J See FigTo Stop Mower Blades Reverse Operation System ROSTo Operate on Hills To Transport See FigService REMINDER/HOUR Meter Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips Purge TransmissionAutomatic Transmission Warm UP Maintenance MaintenanceGeneral Recommendations ScheduleBattery TractorBlade Care Blade Removal See FigEngine Cleaning IN-LINE Fuel Filter See FigDeck Washout Port See Fig Service and Adjustments To Install Mower See FigsTo Remove Mower See Fig Raise attachment lift lever to highest position To Level Mower To Replace Mower Blade Drive Belt To Check BrakeTo Start Engine with a Weak Battery See Fig To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTransmission Storage OtherFuel System Engine OILTroubleshooting Problem Cause CorrectionTo run when oper Battery will notFires when turn Engine continuesSchematic SCH12Electrical KEY Part Description 196 Chassis Drive Nut U-CHNL 1/4-20 550DP .350 PNL Spark Arrester KIT EngineEngine Power Rating Information Steering Assembly 532 41 Wheel, Steering Seat Assembly 532 42 SeatDecals Wheels and TiresMower Deck Tractor Model NO. YTH2242 TF 96041022400, Product no 41 Mower Lift 532 40 34-07 Link Lift Susp Mower RearSuggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX12.16.10 TH

YTH2242 TF specifications

The Husqvarna YTH2242 TF is a versatile and efficient riding mower that combines power, ease of use, and advanced technology to provide an exceptional mowing experience. Designed for residential use, this model is ideal for homeowners with medium to large lawns, ensuring a well-manicured appearance with minimal effort.

One of the standout features of the YTH2242 TF is its robust 22 horsepower Kohler engine. This powerful engine ensures reliable performance and ample torque to tackle even the toughest mowing conditions. Whether you are navigating uneven terrains or thick grass, this engine provides the performance needed to get the job done efficiently.

The mower features a 42-inch cutting deck, which is designed to cover a larger area in a shorter time, making mowing less of a chore. The cutting deck is made from high-quality materials, ensuring durability and resistance against wear and tear. With the ability to adjust cutting heights quickly, users can easily customize their mowing experience according to their lawn’s needs.

Equipped with a hydrostatic transmission, the Husqvarna YTH2242 TF offers smooth and seamless speed changes without the need to shift gears. This feature allows for enhanced maneuverability and control, enabling the operator to focus more on navigating the lawn rather than constantly adjusting the speed.

The mower's ergonomically designed seat provides comfort during extended mowing sessions. The steering wheel is positioned to enhance visibility and ease of operation, ensuring that users can maintain focus on the landscape ahead. Additionally, the onboard storage compartment makes it convenient to keep essential tools and items close at hand.

Safety is a top priority in the design of the YTH2242 TF. The mower is equipped with safety features such as a blade brake that automatically engages when the operator leaves the seat. This ensures that the blades stop rapidly, reducing the risk of accidents.

Furthermore, the Husqvarna YTH2242 TF supports various accessories, enhancing its functionality. Options include mulch kits, baggers, and tow-behind carts, making it a truly adaptable machine for diverse lawn care tasks.

In summary, the Husqvarna YTH2242 TF is a powerful riding mower that offers reliability, comfort, and advanced features, making it an excellent choice for homeowners seeking to maintain their lawns with precision and ease. With its combination of cutting-edge technology and user-friendly design, the YTH2242 TF stands out in the residential lawn care market.