Husqvarna YTH2242 TF owner manual Tractor, Blade Care, Blade Removal See Fig, Battery

Page 15

MAINTENANCE

TRACTOR

Always observe safety rules when performing any maintenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO CHECK BRAKE” in the Service and Adjustments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See the sides of tires for proper PSI).

•Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OPERATION SYSTEM (ROS) (See Fig. 14)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

 

 

 

 

 

 

 

 

 

 

02828

ROS "ON"

ENGINE "ON" POSITION

POSITION

(NORMAL OPERATING)

 

 

 

 

 

 

Fig. 14

15

BLADE CARE

For best results mower blades must be kept sharp. Replace bent or damaged blades.

CAUTION: Use only a replacement blade ap- proved by the manufacturer of your tractor. Using a blade not approved by the manu- facturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 15)

•Raise mower to highest position to allow access to blades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

•Remove blade bolt by turning counterclockwise.

•Install new or resharpened blade with stamped "THIS SIDE UP" facing deck and mandrel assembly.

IMPORTANT: TO ENSURE PROPER ASSEMBLY, CENTER HOLE IN BLADE MUST ALIGN WITH STAR ON MANDREL ASSEMBLY.

•Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: SPECIAL BLADE BOLT HEAT TREATED.

MANDREL ASSEMBLY

 

BLADE

BLADE BOLT

STAR

(SPECIAL)

CENTER HOLE

Fig. 15

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour.

NOTE:Theoriginalequipmentbatteryonyourtractorismain- tenance free. Do not attempt to open or remove caps or cov- ers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

•Raise seat.

•Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

•Rinse the battery with plain water and dry.

•Clean terminals and battery cable ends with wire brush until bright.

•Coat terminals with grease or petroleum jelly.

•Reinstall battery (See “REPLACING BATTERY" in the SERVICEANDADJUSTMENTSsectionofthismanual).

Page 14 Page 16
Image 15
Page 14 Page 16
Contents YTH2242 TF II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Toremovetractorfromcarton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation CJK Know Your TractorStopping See Fig HOW to USE Your TractorAttachment Clutch Switch Disengaged Engaged To SET Parking BRAKESee FigTo USE Cruise Control J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See FigTo Transport See Fig To Stop Mower BladesReverse Operation System ROS To Operate on HillsADD Gasoline Service REMINDER/HOUR MeterBefore Starting the Engine Check Engine OIL LevelMowing Tips Purge TransmissionAutomatic Transmission Warm UP Schedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Blade CareEngine Cleaning IN-LINE Fuel Filter See FigDeck Washout Port See Fig Service and Adjustments To Install Mower See FigsTo Remove Mower See Fig Raise attachment lift lever to highest position To Level Mower To Check Brake To Replace Mower Blade Drive BeltTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBERTransmission Engine OIL StorageOther Fuel SystemProblem Cause Correction TroubleshootingEngine continues To run when operBattery will not Fires when turnSCH12 SchematicElectrical KEY Part Description 196 Chassis Drive Nut U-CHNL 1/4-20 550DP .350 PNL Engine Spark Arrester KITEngine Power Rating Information Steering Assembly 532 41 Wheel, Steering 532 42 Seat Seat AssemblyWheels and Tires DecalsMower Deck Tractor Model NO. YTH2242 TF 96041022400, Product no 41 532 40 34-07 Link Lift Susp Mower Rear Mower LiftOnly Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation12.16.10 TH

YTH2242 TF specifications

The Husqvarna YTH2242 TF is a versatile and efficient riding mower that combines power, ease of use, and advanced technology to provide an exceptional mowing experience. Designed for residential use, this model is ideal for homeowners with medium to large lawns, ensuring a well-manicured appearance with minimal effort.

One of the standout features of the YTH2242 TF is its robust 22 horsepower Kohler engine. This powerful engine ensures reliable performance and ample torque to tackle even the toughest mowing conditions. Whether you are navigating uneven terrains or thick grass, this engine provides the performance needed to get the job done efficiently.

The mower features a 42-inch cutting deck, which is designed to cover a larger area in a shorter time, making mowing less of a chore. The cutting deck is made from high-quality materials, ensuring durability and resistance against wear and tear. With the ability to adjust cutting heights quickly, users can easily customize their mowing experience according to their lawn’s needs.

Equipped with a hydrostatic transmission, the Husqvarna YTH2242 TF offers smooth and seamless speed changes without the need to shift gears. This feature allows for enhanced maneuverability and control, enabling the operator to focus more on navigating the lawn rather than constantly adjusting the speed.

The mower's ergonomically designed seat provides comfort during extended mowing sessions. The steering wheel is positioned to enhance visibility and ease of operation, ensuring that users can maintain focus on the landscape ahead. Additionally, the onboard storage compartment makes it convenient to keep essential tools and items close at hand.

Safety is a top priority in the design of the YTH2242 TF. The mower is equipped with safety features such as a blade brake that automatically engages when the operator leaves the seat. This ensures that the blades stop rapidly, reducing the risk of accidents.

Furthermore, the Husqvarna YTH2242 TF supports various accessories, enhancing its functionality. Options include mulch kits, baggers, and tow-behind carts, making it a truly adaptable machine for diverse lawn care tasks.

In summary, the Husqvarna YTH2242 TF is a powerful riding mower that offers reliability, comfort, and advanced features, making it an excellent choice for homeowners seeking to maintain their lawns with precision and ease. With its combination of cutting-edge technology and user-friendly design, the YTH2242 TF stands out in the residential lawn care market.
Top Page Image Contents