Husqvarna YTH2242 TF owner manual To Replace Motion Drive Belt See Fig, Front Wheel TOE-IN/CAMBER

Page 22

SERVICE AND ADJUSTMENTS

TO REPLACE MOTION DRIVE BELT (See Fig. 34)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

1.Remove mower (See “TO REMOVE MOWER” section in this manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

2.Disconnect clutch wire harness (A).

3.Remove anti-rotation link (B) on right side of tractor.

4.Removebeltfromstationaryidler(C)andclutchingidler(D).

5.Remove belt from centerspan idler (E).

6.Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades (F).

7.Remove belt downward from engine pulley and around electric clutch (G).

8.Slide belt toward rear of tractor, off the steering plate

(H) and remove from tractor.

BELT INSTALLATION -

1.Install new belt from tractor rear to front, over the steer- ing plate (H) and above clutch brake pedal shaft (J).

2.Pull belt toward front of tractor and roll belt around electric clutch and onto engine pulley (G).

3.Pull belt toward rear of tractor. Carefully work belt down around transmission cooling fan and onto the input pul- ley (F). Be sure belt is inside the belt keeper.

4.Install belt on centerspan idler (E).

5.Installbeltthroughstationaryidler(C)andclutchingidler(D).

6.Reinstall anti-rotation link (B) on right side of tractor. Tighten securely.

7.Reconnect clutch harness (A).

8.Make sure belt is in all pulley grooves and inside all belt guides and keepers.

9.Install mower (See “TO INSTALL MOWER” section in

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 35)

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

RETAINING WASHERS

RING

AXLE

COVER

SQUARE KEY (REAR

WHEEL ONLY)

Fig. 35

TO START ENGINE WITH A WEAK BATTERY (See Fig. 36)

this manual).

B A

G

H

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the MAINTENANCE sec- tion of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

 

C

D

J

 

E

F

02953 electric

Fig. 34

22

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

Page 21 Page 23
Image 22
Page 21 Page 23
Contents YTH2242 TF General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Unassembled Parts AssemblyTools Required for Assembly ToremovetractorfromcartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor CJKTo SET Parking BRAKESee Fig HOW to USE Your TractorAttachment Clutch Switch Disengaged Engaged Stopping See FigTo Move Forward and Backward See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To USE Cruise Control J See FigTo Operate on Hills To Stop Mower BladesReverse Operation System ROS To Transport See FigCheck Engine OIL Level Service REMINDER/HOUR MeterBefore Starting the Engine ADD GasolinePurge Transmission Mowing TipsAutomatic Transmission Warm UP General Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine IN-LINE Fuel Filter See Fig CleaningDeck Washout Port See Fig To Install Mower See Figs Service and AdjustmentsTo Remove Mower See Fig Raise attachment lift lever to highest position To Level Mower To Replace Mower Blade Drive Belt To Check BrakeFront Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigTo Replace Motion Drive Belt See Fig To Remove Wheel for Repairs See FigTransmission Fuel System StorageOther Engine OILTroubleshooting Problem Cause CorrectionFires when turn To run when operBattery will not Engine continuesSchematic SCH12Electrical KEY Part Description 196 Chassis Drive Nut U-CHNL 1/4-20 550DP .350 PNL Spark Arrester KIT EngineEngine Power Rating Information Steering Assembly 532 41 Wheel, Steering Seat Assembly 532 42 SeatDecals Wheels and TiresMower Deck Tractor Model NO. YTH2242 TF 96041022400, Product no 41 Mower Lift 532 40 34-07 Link Lift Susp Mower RearSuggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX12.16.10 TH

YTH2242 TF specifications

The Husqvarna YTH2242 TF is a versatile and efficient riding mower that combines power, ease of use, and advanced technology to provide an exceptional mowing experience. Designed for residential use, this model is ideal for homeowners with medium to large lawns, ensuring a well-manicured appearance with minimal effort.

One of the standout features of the YTH2242 TF is its robust 22 horsepower Kohler engine. This powerful engine ensures reliable performance and ample torque to tackle even the toughest mowing conditions. Whether you are navigating uneven terrains or thick grass, this engine provides the performance needed to get the job done efficiently.

The mower features a 42-inch cutting deck, which is designed to cover a larger area in a shorter time, making mowing less of a chore. The cutting deck is made from high-quality materials, ensuring durability and resistance against wear and tear. With the ability to adjust cutting heights quickly, users can easily customize their mowing experience according to their lawn’s needs.

Equipped with a hydrostatic transmission, the Husqvarna YTH2242 TF offers smooth and seamless speed changes without the need to shift gears. This feature allows for enhanced maneuverability and control, enabling the operator to focus more on navigating the lawn rather than constantly adjusting the speed.

The mower's ergonomically designed seat provides comfort during extended mowing sessions. The steering wheel is positioned to enhance visibility and ease of operation, ensuring that users can maintain focus on the landscape ahead. Additionally, the onboard storage compartment makes it convenient to keep essential tools and items close at hand.

Safety is a top priority in the design of the YTH2242 TF. The mower is equipped with safety features such as a blade brake that automatically engages when the operator leaves the seat. This ensures that the blades stop rapidly, reducing the risk of accidents.

Furthermore, the Husqvarna YTH2242 TF supports various accessories, enhancing its functionality. Options include mulch kits, baggers, and tow-behind carts, making it a truly adaptable machine for diverse lawn care tasks.

In summary, the Husqvarna YTH2242 TF is a powerful riding mower that offers reliability, comfort, and advanced features, making it an excellent choice for homeowners seeking to maintain their lawns with precision and ease. With its combination of cutting-edge technology and user-friendly design, the YTH2242 TF stands out in the residential lawn care market.
Top Page Image Contents