OPERATION
ADVANCING THE CUTTING LINE
AUTOMATICALLY
See Figure 7.
The trimmer includes the EZ Line™ Tap Advance
System.
Follow these steps to advance the cutting line automatically.
1.Press the trigger and run at full speed.
2.Tap the retaining cap lightly on the ground while the motor is running. Do not hold the retaining cap on the ground.
Note: The line cutting blade on the grass deflector will cut the line to the proper length.
Note: To help prevent line tangle, tap only once to lengthen the line. If additional line is required, wait a few seconds before retapping the retaining cap. Keep the line length at or near full cutting diameter.
ADVANCING THE CUTTING LINE
MANUALLY
See Figure 8.
If the cutting line wears to less than the recommended length, you may not be able to lengthen it by tapping the retaining cap.
Follow these steps to advance the cutting line manually.
1.Release the trigger and allow the trimmer to coast to a stop.
2.Unplug the trimmer.
3.Pull sharply on the line while pushing down on the retaining cap.
Page 11
RETAINING
CAP
Fig. 7
LINE
RETAINING
CAP
Fig. 8