Homelite UT41002 manual Troubleshooting, Problem Possible Cause Solution

Page 14

TROUBLESHOOTING

PROBLEM	POSSIBLE CAUSE	SOLUTION

Line will not advance when tap retaining cap

1.Line is welded to itself.

2.Not enough line on spool.

3.Line is worn too short.

4.Line is tangled on spool.

1.Lubricate with Homelite silicone spray.

2.Install more line (Refer to “Replacing the Cutting Line” earlier in this manual).

3.Pull lines while alternately pressing down on and releasing spool retainer.

4.Remove line from spool and rewind (Refer to “Replacing the Cutting Line” earlier in this manual).

Retaining cap is hard to turn	Screw threads are dirty or dam-
	aged.

Clean threads and lubricate with grease. If no improvement, replace spool retainer.

Grass wraps around the attachment shaft and the trimmer head assembly

Cutting tall grass at ground level. Cut tall grass from the top down.

Page 14

Image 14

Contents Operators Manual Table of Contents IntroductionSpecific Trimmer Safety Rules SafetyGeneral Safety Rules Electrical Safety RulesStorage and Transportation Rules Maintenance RulesService Rules Symbols Symbol Name ExplanationDrive Shaft and Cutting Head SpecificationsUnpacking InformationFeatures Removing the Attachment from the Upper Shaft AssemblyConnecting the Attachment to the Upper Shaft Attaching the Front HandleAttaching the Grass Deflector Operating the Trimmer OperationStarting and Stopping the Trimmer Cutting TipsRetaining CAP Line Advancing the Cutting Line AutomaticallyAdvancing the Cutting Line Manually Servicing the Trimmer MaintenanceCleaning the Trimmer Replacing the Cutting LineReplacing the Spool Drive Shaft Trimmer Head SpoolTroubleshooting Problem Possible Cause SolutionAccessories Warranty Limited Warranty StatementPage Customer Service Information