ASSEMBLY
Assembly of the blade and trimmer head
Assembling the blade guard and clearing blade
It is extremely important that the disc drive’s/support flange’s guide engages correctly in the cutting equipment’s centre hole when assembling the cutting equipment. Cutting equipment assembled incorrectly can result in serious and/or fatal personal injury.
!WARNING!
Do not attach any blade to the unit without proper installation of all required parts. Failure to use the proper parts can cause the blade to fly off and seriously injure the operator and/or bystanders.
Under no circumstances may the cutting equipment be used without an approved guard fitted. See the chapter “Technical data”. If the wrong guard or a defective guard is fitted this can cause serious personal injury.
IMPORTANT INFORMATION
The machine must be equipped with the correct handlebars, blade guard and harness if either a clearing blade or grass blade are to be used.
Assembling the blade guard and | |||
grass blade |
|
| |
• Hook the guard (A) onto |
|
| |
the bracket on the shaft |
| G | |
and secure with 1 bolt. |
| ||
| F | ||
NOTE! Use the |
| E | |
recommended blade |
| ||
|
| ||
guard. “See Technical |
| D | |
data“. |
| ||
|
| ||
• Fit the drive disc (B) on |
|
| |
the output axle. | A | B | |
• Turn the blade axle until | |||
| |||
| C | ||
one of the holes in the |
| ||
|
| ||
drive disc aligns with the |
|
| |
hole in the gear housing. |
|
| |
•Insert the locking pin (C) in the hole so that the axle is locked.
•Place the blade (D),
support cup (E) and support flange (F) on the output axle.
•Fit the nut (G). The tightening torque of the
nut is
kpm). Use the socket spanner in the tool kit. Hold the handle of the spanner as close to the blade guard as possible. The nut is tightened when the spanner is turned against the direction of rotation
•Remove the mounting plate (H). Fit the adapter
(I) and bracket (J) with the two screws (K) as shown. Fit the blade guard (A) to the adapter using the 4 screws (L) as shown.
NOTE! Use the recommended blade guard. “See Technical data“.
•Fit the drive disc (B) on the output axle.
•Turn the blade axle until one of the holes in the drive disc aligns with the hole in the gear housing.
•Insert the locking pin (C) in the hole so that the axle is locked.
•Place the blade (D) and support flange (F) on the output axle.
•Fit the nut (G). The tightening torque of the nut is
•When slacking off and tightening the saw blade nut, the hands may be injured by the blade teeth. Always hold your hand protected by the blade guard. This is facilitated by the use of a long box spanner. The illustration shows the area in which you should keep the box spanner.
H |
K |
J |
I |
A |
L |
G |
F |
D |
B |
C |
18 – English