|
|
|
| ASSEMBLY |
|
| ||
3.3 Hydraulic Boiler to Tank Connections Kit (BH46) |
| |||||||
Assembly |
|
| ||||||
|
|
| ||||||
|
|
|
|
|
| |||
|
| |||||||
|
|
| ||||||
%!" |
|
|
| |||||
'""#$&""'("")**+ |
|
|
|
| ||||
Connection kit BH46, provides connections from the tank to the boiler.
The kit consists of
-A pump with cable 3
-Insulated flexible connector 13, length 1120mm
-Insulated flexible connector with elbow 12, length 1200mm
-A bag containing:
-An antisyphon valve 10
-Connecting union 4
-Tee with union nut 1
-Tee 7
-Tee with tappings 9
-3 X 1/2" plugs 11
-3 X 1 1/2" O rings 5
-5 X 3/4" O rings 14
-4 X plastic plugs 15
-Flexible clip 16 with fixing 17
IMPORTANT
-Ensure access to pump speed control and vent screw V
-Ensure flexible connectors are run to prevent air pockets
-The 1/2" plug 11 fitted to Tee 1 can be replaced by a drain cock
-To ensure best venting of the assembly and continued good operation of the installation, an automatic vent (P) not supplied, should be fitted on Tee 9 (1/2")
-Screw the Tee with union nut 1 and plug 2 on tank outlet D
-Fit the pump 3 to union nut 4 and Tee 1 inserting O rings 5
-Screw Tee 7 to boiler return B
-Screw Tee with tappings 9 with plug 11 to boiler flow A
-Screw valve Tee 10 with plug 11 to tank inlet C
-Connect elbow flexible 12 (1200mm) between 7 & 4 and flexible 13 (1120mm) between 9 & 10 inserting O rings 14.
-Assemble flexible clip 16 and fitting 17 then clip them in the 7.5mm hole E on the boiler rear panel.
-Fit flexible 13 in clip 16.
The pump cable allows simple connection to the boiler control box. See Electrical section for further information.
Buccaneer GT, Falcon GTE - Installation, Assembly & Servicing | 13 |
