ASSEMBLY | ||
4.3 Electrical Connections | The connecting cables may be brought inside the boiler through | |
The electrical wiring has been carefully checked in the factory and | the | |
along with purchased cable channels. | ||
the internal connections of the control panel must not be modified | ||
Fasten the cables to the rear plate of the control panel by means of | ||
in any event. | ||
The electrical connections of the boiler shall be made in compliance | the cable clamps (supplied in the instructions bag), after mounting | |
them on the plate. | ||
with applicable standards and regulations in force. | ||
The pump cable has a connector fitted. Discard the connector. | ||
The unit shall be powered by a circuit with an omnipole switch with | ||
| ||
an opening distance greater than 3 mm. | WARNING | |
| ||
WARNING | VERY IMPORTANT: never place sensor cables | |
Electrical connections shall be carried out by a | (extra low voltage) and 230 V power supply cables | |
in the same cable channel or duct. | ||
qualified professional only. |
| |
| All the connections shall be made to the connection strip provided | |
| for that purpose outside the volume of the control panel. | |
Refer to Boiler Assembly Instructions for Control Panel Installation | ||
| ||
4.4 Installation with MB1 Domestic Hot water Priority and Regulation Mode
Fitting and Connecting the MB1 Module
Fit the MB1 module on the front of the control panel. Proceed as follows:
1. Remove the cover: cut the four fixing studs of the cover with a knife and fold it outward.
2. Install and connect the MB1 module as directed on pages
BUC5042
Buccaneer GT, Falcon GTE - Installation, Assembly & Servicing | 15 |
