Husqvarna 326HDA55X-Series, 326HE3X-Series, 326HE4X-Series manual Basic working techniques

Page 10

SAFETY INSTRUCTIONS

Protective instructions when work is completed

The transport guard should always be fitted to the blades when the machine is not in use.

Ensure the blades have stopped and remove the spark plug cable from the spark plug before carrying out cleaning, repairs or an inspection.

Always wear heavy duty

gloves when repairing the blades. The blades are extremely sharp and can easily causes cuts.

• Store the machine out of reach from children.

Only use original spare parts when carrying out repairs.

Basic working techniques

Work with a swinging

action from the bottom upwards when trimming sides.

• Adapt the throttle according to resistance.

• When trimming a hedge the engine should always be turned away from the hedge.

• The hedge trimmer should be held as close to the body as possible to get the best balance.

Make sure that the tip

does not touch the ground.

• Do not try to force the

work, but move at a steady speed so that all the stems are cut evenly.

Changing the hedge trimmer angle

(326HE3, 326HE4)

• Loosen the knob on the angle adjuster.

Grasp the handle on the angle adjuster, adjust to

the desired angle and tighten the knob.

(326HDA55)

Loosen the knob on the angle adjuster.

Press the cutting attach-

ment against the ground or some other solid object to set the desired angle.

Tighten the knob.

NOTE! Do not hold the cutting attachment when you adjust the angle. The blades are sharp and you could easily cut yourself.

10 – English

Image 10
Contents 326HDA55X-series Symbol Explanation SymbolsContents Personal protective eqipment Safety InstructionsMachine’s protective equipment Muffler Vibration damping systemBlade guard 326HDA55 Hand guard 326HDA55, 326HE3 Blades GearboxStart General safety instructionsFuel safety Transport and storageProtective instructions regarding the surroundings Safety instructions when using the hedge trimmerPersonal protection Protective instructions while workingChanging the hedge trimmer angle 326HE3, 326HE4 Protective instructions when work is completedBasic working techniques 326HDA55What is WHAT? What is what on the hedge trimmer?Adjusting the harness 326HE4 AssemblyFitting the angle adjuster 326HE3/ 326HE4 Fitting the cutting attachmentFuel Fuel HandlingFuelling Start and stop Start and StopControl before starting StopMaintenance CarburettorAdjusting the idle speed, T High speed needle H Correctly adjusted carburettorCooling system MufflerSpark plug Air filter Cleaning and lubricationCleaning the air filter GearboxWeekly maintenance Maintenance scheduleDaily maintenance Monthly maintenanceTechnical Data Technical data 326HDA55 326HE3 326HE4Emission Control Warranty Statement ´+H¶3~¨ Page 114 00 2001W51