Husqvarna 326HDA55X-Series, 326HE3X-Series, 326HE4X-Series manual Air filter, Gearbox

Page 18

MAINTENANCE

Air filter

The air filter (A) should be cleaned regularly removing dust and dirt to avoid:

carburettor malfunction

starting problems

reduced engine power

unnecessary wear to engine parts

abnormal fuel consumption

Clean the filter after every 25 hours or more regularly if operating conditions are exceptionally dusty.

Cleaning the air filter

Dismantle the air filter cover (B) and remove the air filter. Wash in clean, warm soapy water. Ensure that the filter is dry before refitting.

An air filter used for a long period of time can never be cleaned completely. Therefore it is necessary to replace the filter from time to time with a new filter. A damaged air filter must always be replaced.

If the machine is used in dusty conditions the air filter should be soaked in oil, see the section on “Oiling the air filter“.

Oiling the air filter Always use HUSQVARNA filter oil, order no. 503 47

73-01. The filter oil contains a solvent to make it spread evenly through the filter. You should therefore avoid skin contact. Put the filter in a plastic bag and the pour the filter oil over it. Knead the plastic bag to distribute the oil. Squeeze the excess oil out of the filter inside the plastic bag and pour off the excess before fitting the filter on the machine. Never use common engine oil. This would drain through the filter quite quickly and collect in the bottom.

Gearbox

There are three grease nipples on the gearbox. Use a grease gun to top up with grease. This should be carried out after approximately every 20 working hours. Use Husqvarna special grease, No. 503 98 96-01.

Note that the gearbox must not be filled completely with grease. The grease expands as the machine heats up during operation. If the gearbox was completely filled with grease it could damage the seals and lead to leakage.

The lubricant in the gearbox does not normally need to be replaced other than with repair.

Cleaning and lubrication

After you have used the machine clean any resin and plant residue from the blades using cleaning agent 531 00 60-75 (UL22).

Always lubricate the blade runners with special grease 531 00 60-74 (UL 21) before use.

18 – English

Image 18
Contents 326HDA55X-series Symbol Explanation SymbolsContents Safety Instructions Personal protective eqipmentMachine’s protective equipment Vibration damping system MufflerBlade guard 326HDA55 Hand guard 326HDA55, 326HE3 Blades GearboxStart General safety instructionsFuel safety Transport and storageProtective instructions regarding the surroundings Safety instructions when using the hedge trimmerPersonal protection Protective instructions while workingChanging the hedge trimmer angle 326HE3, 326HE4 Protective instructions when work is completedBasic working techniques 326HDA55What is WHAT? What is what on the hedge trimmer?Adjusting the harness 326HE4 AssemblyFitting the angle adjuster 326HE3/ 326HE4 Fitting the cutting attachmentFuel Handling FuelFuelling Start and stop Start and StopControl before starting StopMaintenance CarburettorAdjusting the idle speed, T High speed needle H Correctly adjusted carburettorMuffler Cooling systemSpark plug Air filter Cleaning and lubricationCleaning the air filter GearboxWeekly maintenance Maintenance scheduleDaily maintenance Monthly maintenanceTechnical Data Technical data 326HDA55 326HE3 326HE4Emission Control Warranty Statement ´+H¶3~¨ Page 114 00 2001W51