ASSEMBLY
Fitting the hand guard and loop handle(326HDA55/326HE3)
1.Assemble the hand guard and loop handle by screwing them together.
Take care to align the holes in both parts.
2. Slide the loop handle and the hand guard onto the shaft.
3. Slide the spacer into the slot in the loop handle.
4. Fit the nut and bolt. Do not
5. Adjust to give a comfortable working position. Tighten the nut. NOTE! The loop handle and hand guard must not be fitted behind the arrow marked on the shaft.
Fitting the angle adjuster (326HE3/ 326HE4)
1.Fit the angle adjuster over the two holes in the
cutting attachment. NOTE! The angle adjuster must be fitted on the side nearest the shaft.
2.Fit the two washers and short screws. Tighten the
screws.
3. Fit the long screw, the washer and the knob.
Fitting the cutting attachment
Lay the hedge trimmer on a flat surface before fitting the cutting attachment. Otherwise the cutting attachment may not be fitted straight.
1. Fit the cutting attachment to the shaft.
NOTE! Make sure the drive shaft on the shaft is aligned with the
2.Tighten the lower screw, followed by the upper screw.
Adjusting the harness (326HE4)
You should always use the harness with the machine to give maximum control and reduce strain on your arms and back.
1.Put on the harness.
2.Hook the machine onto the hook on the harness.
3.Adjust the length of the
harness so that the hook is roughly level with your right hip.
12 – English