Husqvarna Air filter, Angle gear, 326Ex 326ES, Cleaning the air filter, Oiling the air filter

Page 24

MAINTENANCE

mm). The spark plug should be replaced after about a month in operation or earlier if necessary.

CAUTION! Always use the recommended spark plug type! Use of the wrong spark plug can damage the piston/ cylinder. Check that the spark plug is fitted with a suppressor.

Air filter

The air filter must be regularly cleaned to remove dust and dirt in order to avoid:

Carburettor malfunctions

Starting problems

Loss of engine power

Unnecessary wear to engine parts

Excessive fuel consumption.

Clean the filter every 25 hours, or more regularly if conditions are exceptionally dusty.

Cleaning the air filter

Remove the air filter cover and take out the filter. Wash it clean in warm, soapy water. Ensure that the filter is dry before refitting it.

An air filter that has been in use for a long time cannot be cleaned completely. The filter must therefore be replaced with a new one at regular intervals. A damaged air filter must always be replaced.

If the machine is used in dusty conditions the air filter should be soaked in oil. See instructions under the heading Oiling the air filter.

Oiling the air filter

Always use HUSQVARNA filter oil, art. no. 531 00 92-48. The filter oil contains a solvent to make it spread evenly through the filter. You should therefore avoid skin contact.

Put the filter in a plastic bag and pour the filter oil over it. Knead the plastic bag to distribute the oil. Squeeze the excess oil out of the filter inside the plastic bag and pour off the excess before fitting the filter to the machine. Never use common engine oil. This would drain through the filter quite quickly and collect in the bottom.

Angle gear

The angle gear is filled with a sufficient quantity of grease at the factory. However, before using the machine you should check that the angle gear is filled to 3/4 with grease. Use HUSQVARNA special grease.

326Ex 326ES

The grease in the bevel gear does not normally need to be changed except if repairs are carried out.

24 – English

1151020-95 Rev. 2 2008-03-10

Image 24
Contents 326ES 326EX-series KEY to Symbols SymbolsContents Introduction Dear customerWhat is WHAT? What is what? 326ExWhat is what? 326ES General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system Muffler Cutting equipmentLocking nut 326Ex Locking screw 326ESAssembly Fitting the loop handleAssembling the angle gear 326Ex Assembling the angle gear 326ESAssembling the cutting equipment Assembling the blade 326ExAssembling the blade 326ES Fuel safety Fuel HandlingFuel Fueling MixingStarting and Stopping Check before startingStarting and stopping StartingStopping Working Techniques General working instructionsSafety instructions while working Basic working techniquesSafety instructions after completing work Maintenance CarburetorFine adjustment of the idle speed T Correctly adjusted carburetorLow speed jet L High speed jet HMuffler Cooling systemSpark plug Cleaning the air filter Air filterAngle gear 326Ex 326ESAdjusting the edger’s cutting depth 326Ex Adjusting the edger’s cutting depth 326ESLubricating the flexible drive shaft 326Ex Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataYour Warranty Rights and Obligations Emission Warranty Parts List Page Page 1151020-95