Husqvarna 326ES manual Assembly, Fitting the loop handle, Assembling the angle gear 326Ex

Page 12

ASSEMBLY

Fitting the loop handle

•Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft.

•Fit the bolt, securing plate and wing nut as shown in the diagram.

•Tighten the wing nut.

Assembling the angle gear (326Ex)

•Assemble the angle gear back on the suppporting tube. Turn the blade so that the drive shaft engages in the angle gear.

•Position the angle gear so that its slot is aligned with the line on the supporting tube.

•Firmly tighten the screw.

Assembling the angle gear (326ES)

•Assemble the angle gear back on the suppporting tube. Turn the blade so that the drive shaft engages in the angle gear.

•Tighten the two screws.

12 – English

1151020-95 Rev. 2 2008-03-10

Image 12

Contents 326ES 326EX-series KEY to Symbols SymbolsContents Introduction Dear customerWhat is WHAT? What is what? 326ExWhat is what? 326ES General Safety Precautions Personal protective equipmentMachine′s safety equipment Throttle lockoutStop switch Cutting attachment guardVibration damping system Mufﬂer Cutting equipmentLocking nut 326Ex Locking screw 326ESAssembly Fitting the loop handleAssembling the angle gear 326Ex Assembling the angle gear 326ESAssembling the cutting equipment Assembling the blade 326ExAssembling the blade 326ES Fuel safety Fuel HandlingFuel Fueling MixingStarting and Stopping Check before startingStarting and stopping StartingStopping Working Techniques General working instructionsSafety instructions while working Basic working techniquesSafety instructions after completing work Maintenance CarburetorFine adjustment of the idle speed T Correctly adjusted carburetorLow speed jet L High speed jet HMufﬂer Cooling systemSpark plug Cleaning the air ﬁlter Air ﬁlterAngle gear 326Ex 326ESAdjusting the edger’s cutting depth 326Ex Adjusting the edger’s cutting depth 326ESLubricating the ﬂexible drive shaft 326Ex Maintenance schedule Maintenance Daily Weekly MonthlyTechnical Data Technical dataYour Warranty Rights and Obligations Emission Warranty Parts List Page Page 1151020-95