SECTION 2 INSTALLATION

6.Slide the top transition panel into place. Then, slide the two transition side panels into place. See Figure 2-29.

5.For a TANDEM, DOUBLE TANDEM, or TRI TANDEM oven installation, skip ahead to the next section. For a QUAD TANDEM oven installation, continue on to Step 6.

Latches

7.If the four latches are not already attached to the side and top transition panels, attach them in place as shown in Figure 2-29.

Fasten the latches on the side and top panels to hold the panels in place.

8.LOOSELY attach the conveyor drive motor to the end wall of the oven, as shown in Figure 2-30.

9.Assemble the conveyor drive chain in place on the motor and conveyor drive sprockets.

10.Position the motor to adjust the tension of the drive chain. The deflection of the chain should not exceed 1/4” (6mm). Then, tighten the motor in place.

Figure 2-29

Transition

Assembly

Latches

Figure 2-30

Conveyor Motor and Drive Chain Assembly

11.Assemble the end plugs and motor housing onto the oven.

TANDEM AND DOUBLE TANDEM OVENS ONLY: Assemble the conveyor crumb trays and conveyor extension covers onto the oven.

2-21

Page 21
Image 21
Middleby Marshall Oven owner manual Transition Assembly, Conveyor Motor and Drive Chain Assembly