Middleby Marshall Oven Positioning and Alignment, Cooling Fan Removal, Joining the Oven Bodies

SECTION 2

INSTALLATION

JOINING THE OVEN BODIES

For TANDEM and DOUBLE TANDEM installations, perform

Steps 1-7 to join the ovens.

For TRI TANDEM installations, perform Steps 1-7 to join two of the ovens together, and ensure that they are level; then, repeat Steps 1-7 to join the third oven to the two that are assembled.

For QUAD TANDEM installations, perform Steps 1-7 for EACH PAIR of ovens, producing two sets of two joined ovens. Do not assemble the center bridge section at this time.

1.Determine the proper position of the ovens by referring to Figure 2-15. Then, move the ovens to their approximate final locations.

NOTE: The Sealing Gasket Assembly is shown attached to the left oven in Figure 2-15, but may be pre-mounted to EITHER of the two ovens.

LEFT OVEN	Alignment
	plate

Slot for

alignment

plate

Sealing gasket assembly (pre- mounted)

RIGHT OVEN

2.Remove the rear axial cooling fans that are adjacent to the mating sides of the ovens, as shown in the diagram. Leave the fan wiring connected to the oven.

Figure 2-15

Oven Positioning and Alignment

Mating surface of

ovens (shown

from lower rear)

Wiring is still

connected

Figure 2-16

Cooling Fan Removal

2-14