SECTION 2

INSTALLATION

IV. THERMOCOUPLE

INSTALLATION

1. Install the thermocouple sensing bulb into the correct hole in rear of bake chamber as shown in Figure 2-11.

2. Thread thermocouple lead through grommet and into the machinery compartment.

Figure 2-11

Thermocouple Installation Locations

3. Remove the right-side ac- cess panel of the machinery compartment.

Thread the thermocouple lead through the side of the machin- ery compartment as shown in Figure 2-12, and into the elec- trical box (at the right-front of the machinery compartment).

Figure 2-12

Placing the Thermocouple Leads

2-11

Page 11
Image 11
Middleby Marshall Oven IV. Thermocouple Installation, Thermocouple Installation Locations, Placing the Thermocouple Leads