Husqvarna 335RJ, 335RJX-Series Cooling system, Bevel gear, Air filter, Cleaning the air filter

Page 21

MAINTENANCE

Cooling system

To keep the working temperature as low as possible the machine is equipped with a cooling system.

3 2

1

The cooling system consists of:

1Air intake on the starter.

2Cooling fins on the cylinder.

3Cylinder cover (directs cold air over the cylinder).

Clean the cooling system with a brush once a week, more often in demanding conditions. A dirty or blocked cooling system results in the machine overheating which causes damage to the piston and cylinder.

Bevel gear

The bevel gear is filled with the right quantity of grease at the factory. However, before using the machine you should check that the bevel gear is filled three-quarters full with grease. Use HUSQVARNA special grease.

The grease in the bevel gear does not normally need to be changed except if repairs are carried out.

Air filter

The air filter must be regularly cleaned to remove dust and dirt in order to avoid:

Carburettor malfunctions

Starting problems

Loss of engine power

Unnecessary wear to engine parts.

Excessive fuel consumption.

Clean the filter every 25 hours, or more regularly if conditions are exceptionally dusty.

Cleaning the air filter

Remove the air filter cover and take out the filter. Wash it clean in warm, soapy water. Ensure that the filter is dry before refitting it.

An air filter that has been in use for a long time cannot be cleaned completely. The filter must therefore be replaced with a new one at regular intervals. A damaged air filter must always be replaced.

If the machine is used in dusty conditions the air filter should be soaked in oil. See instructions under the heading Oiling the air filter.

Oiling the air filter

Always use special filter oil. Filter oil contains a solvent to make it spread evenly through the filter. You should therefore avoid skin contact.

Put the filter in a plastic bag and pour the filter oil over it. Knead the plastic bag to distribute the oil. Squeeze the excess oil out of the filter inside the plastic bag and pour off the excess before fitting the filter to the machine. Never use common engine oil. This would drain through the filter quite quickly and collect in the bottom.

English – 21

Image 21
Contents 333RJ 335RJX-series Symbols KEY to SymbolsContents Dear Customer IntroductionWhat is what on the clearing saw? What is WHAT?Personal protective equipment General Safety PrecautionsMachine′s safety equipment Stop switchThrottle lock Cutting attachment guard Vibration damping systemMuffler Cutting equipment Locking nutCutting equipment Trimmer head Sharpening grass cutters and grass bladesFitting the J-handle AssemblyAssembling the cutting equipment Fitting the guard extensionHook the blade guard/combination guard a onto Fuel safety Fuel HandlingFuel Mixing FuellingCheck before starting Starting and StoppingStarting and stopping StartingStopping Working Techniques Basic safety rulesGeneral working instructions Basic working techniquesGrass trimming with a trimmer head Grass clearing using a grass bladeCarburettor MaintenanceCorrectly adjusted carburettor Fine adjustment of the idle speed TMuffler High speed jet HCooling system Cleaning the air filterBevel gear Air filterSpark plug Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical DataApplies to Europe only EC-declaration of conformityPage S35 095-.106 T35 ´z+R3,¶6/¨ Page 1150191-26 ´z+R3,¶6/¨ ´z+R3,¶6/¨